Sentences with phrase «attach the leg using»

To attach the legs I used cold welding or epoxy mastic.

Attach the leg using 1 1/2» pocket hole screws and wood glue.

Once everything was dry, I attached my legs using the angle plates.

Not exact matches

Use small brass paper fasteners (see insert) to attach movable arms and legs.

And if your using as a double stroller your leg will not it the second seat as you have so much room to talk my husband is 6â $ ™ 1 and Iâ $ ™ m 5â $ ™ 6 neither of our feet is hitting the stroller at all with the second seat attached.

Further I would reinforce the mechanism used to attach the bottom corners to the legs.

With one of these sleepers, your baby will be supported by the legs of the crib as well as the suspension, tension, or whichever other method you choose to use to attach the crib to your own adult bed.

Using the ticks» «questing» behaviour in which they wave their forelegs to attach to passing hosts, the researchers collected ticks from material moved through the vegetation in three ways: by hand, attached to their heels and on easily - removable leggings of the same fabric.

In contrast, the Ambler has all its six legs attached to a central shaft and uses a «circulating gait».

Attach one of the 48» boards to the inside legs using the same procedure.

Using a cable machine, attach a rope and face away from the machine, straddling the cable so the rope is in between your legs.

Then use a stainless steel butt hinge to attach the flexible back leg to the top front horizontal pieces of wood.

Use wood glue and 1 1/4 ″ screws to attach the legs to the skirt as shown.

Presence of animal fighting paraphernalia such as: inject able supplements, dog treadmills, written training records, heavily weighted chains used to confine dogs to the ground, knives and gaffs used to attach to the legs of fighting roosters, animal fighting publications that list fights between animals and the sale of paraphernalia used in animal fighting.

At this point, the immature deutonymph attaches itself to a mature male ear mite using suckers on the rear legs.

He used to be pretty independent, but these days, you might as well attach a side cart to your leg so your pup doesn't have to chase you down every time you stand up and walk into another room!

Make sure that you tie up all loose wire and cables, or use cable tacks and attach them firmly to walls or along the baseboard, counter top, up desk legs, etc. so that there's nothing to attract your cat's attention.

The leash, or leg rope as it is also known, is used to attach your board to your leg.

Would you be willing to cut the «legs» off of the mantel and attach just the top to the wall to use as ledge for pretty things?

Why did you decide to change the legs instead of using the legs that were already attached?

Attach the back legs flush to the back panel using 1 1/4» pocket hole screws and wood glue.

You'll use the 4 1/2 - inch HeadLOK screws to attach the leg pieces to the short end.

Looks like an old fashioned metal tray table quite flimsy and unfortunately you can see the indents on the tray top where legs attached beneath was going to use as a side table but will probably now be ideal for garden living as similar to a camping table.

Using a thin layer of glue and 2 additional 3 inch L brackets at the bottom of the center apron piece attach the center piece to the legs.

Attach the dividers between the two front legs using 1 1/4» pocket hole screws and wood glue.

Attach the legs with the side panel using 1 1/4» pocket hole screws and wood glue.

Using wood glue and 2» wood screws attach the top to all 4 legs.

Glue and attach legs to top trim using 2-1/2» trim screws.

Run a bead of liquid nails along the top part of the leg piece, and then using an angle square, line up the shelf legs under the markings on the shelf length and attached with screws, be sure to screw down below the surface of the wood.

Attach to 3/4 ″ plywood to legs, so the top is flush and there is a 1 1/2 ″ space from the inner corner of the legs to the plywood, using 1 1/4 ″ pocket hole screws.