Sentences with phrase «then pin the holes»

Then pin the holes together, matching at the seams and sew.

Not exact matches

I made a thin layer of the dough on baking paper by pressing it and shaping it with my hands (rolling pin just didn't work for me but I can imagine it would work if I put another sheet of baking paper over the dough to avoid contact of the dough with the rolling pin), then I cut it with pizza cutter into little squares, made holes in each square with a fork and baked it * without any turning * for 30 minutes in the oven preheated to 170 degrees Celsius (350 F).

Nichols drove down the middle on the final hole, then caught a three wood a little fat, and the ball stopped on the right edge of the fairway about 30 yards from the pin.

My daughter required the easiest - flow nipples — and even then, we were enlarging the nipple hole with a safety pin.

Then use the pin to create a hole in your ornament for the ribbon to go once dry.

You just remove the quick - pin, swing the bracket forward or backward until the holes line up for the desired width setting, then reinsert the quick - pin.

You then slide the pin through the holes in the first upright, into and through the pipe, and all the way through the rear upright.

You slide a quick - pin into one of the holes the bottom of the bracket, insert it through power rack upright and then out the other side of the bracket.

Step 4: Hot glue the small hole of flower to secure it, and then using extra glue, press on the bar pin into the back of the flower.

I then put the pin through the hole in the dowel rod and bent the back of the pin to secure.

Edith was only ever meant to have been a one - off performance commissioned for The Route 1066 Contemporary Arts Festival, but ultimately it then became a bookwork, a CD, a pin - hole exhibition, an installation and now a feature film.

If the hole in the arm isn't exactly the size of the pin (and it may not be, because this was one way by which the friction was reduced) and if the various experiments didn't previously control for these two related factors, then this could be one possible uncontrolled factor allowing the results to vary more widely than the model and experimental results would otherwise permit.

Mr. Project installed one on the wall with pocket - hole screws, and then installed the second one to the first one with pin nails.

Pin holed any tiny air pockets left, fingered on glue over them to smooth out, then laid a top coat of glue.

Thread a 1 - inch brass ring on the pin, then insert the pin into the holes.