Sentences with phrase «air fuel mixture»

There are basically 3 things you need to consider for timing - engine RPM, air / fuel ratio, and volume of air fuel mixture in the cylinder.

I'm learning about vacuum leaks on engine intakes and I'm hearing this terminology of lean air fuel mixture.

The intake ports create a swirl effect in the cylinder chamber that promote a well balanced and even air fuel mixture as it enters the engine.

They used a system that would kill the spark on the engine (can't remember if they killed spark entirely, switched on / off, half the cylinders, etc.) sending raw air fuel mixture through the exhaust, then ignite it with a coil and spark plug in the exhaust.

The combustion of the compressed air fuel mixture expands as the gasses undergo rapid oxidation, pushing the piston down the bore of the cylinder thereby forcing the connecting rod down and forcing the crankshaft to spin.

Thermal efficiency is less because a part of air fuel mixture gas as waste with the exhaust gas.

As I'm writing this, I'm thinking there is going to be a perfect air fuel mixture through your entire exhaust system, so I'm not sure what kept the entire thing from exploding...

When mechanical systems operate for extended periods, or heat is developed, minor issues tend to be amplified; especially with fuel system components like dirty or clogged fuel injectors, air fuel mixture components or fuel and air filters that...

Direct Gas Injection injects fuel directly into each cylinder for a more precise and effective air fuel mixture.

EcuTek RaceRom Air Fuel Gauge for Subaru BRZ / Scion FR - S EcuTek's latest RaceRom patch now allows you to make the MPG gauge show current Air Fuel Mixture

Off idle and higher the main jet contributes more and more to air fuel mixture as you open the throttle to wide open where the main jet is 99 %...

In direct Injection, the injector sprays the air fuel mixture directly into the cylinder thus you have optimum computer controlled combustion.

On the other hand, a spark plug which is too cold, will tend to not burn all of the air fuel mixture within the cylinder, which also means worse gas mileage and sub-par performance as well.

As @Fred Wilson mentioned in his comment, if the MAF sensor that you replaced isn't the one made specifically for your car, then it won't be able to correctly control the air fuel mixture.

It turned out to be the air fuel mixture, fiddling with the little adjustment screw on the carburettor sorted out the problems.

The air fuel mixture is compressed by the rising piston.

Just before TDC (top dead center) the spark plug has an electric charge jump across it's center and ground electrodes igniting the air fuel mixture in a process called combustion.

It works by having the ability to close off one of the two intake ports near the intake valve at low engine speeds, which speeds up the air entering the cylinder and causes a swirl of the air fuel mixture as it enters.

Yes it will cause a check engine light.The hose is a vacum line for the PVC valve it is to ventilate fumes out of the crankcase and burn them in the combustion process.If disconnected the air fuel mixture will become very lean.Too much air not enough fuel.After reconnecting it may take a few miles for the light to reset.The broken piece in the valve cover would be the PCV valve

This optimises the air fuel mixture for a cleaner, more efficient combustion.

This optimizes the air fuel mixture for a cleaner, more efficient combustion.

The basic job of the sensor is to monitor the air fuel mixture under idle,...

The basic job of the sensor is to monitor the air fuel mixture...