Bend the cardboard between the slits out so it lies flat and
attach pieces of tape to the underneath.
Not exact matches
Cut one inch
pieces of washi
tape in half lengthwise and
attach your craft paper labels on the jar lids.
Cut a
piece of contact paper large enough to cover the tree completely, and
attach it to the wall with masking
tape, sticky side out (see video below to see this part in action).
Use a small
piece of tape at the top
of each flag on the back side to
attach the flag to the string.
Normal adhesives stop being sticky in the cold vacuum, and the force required to
attach a
piece of sticky
tape is enough to make the target object float away.
I just put a
piece of tape on the back
of the card to
attach it to the pumpkin.
I just received a package with the label
attached with a single
piece of Scotch
tape at the top and a
piece of Anthro tissue
tape on the bottom corner.
At the same time, the favorite furniture scratching area can be made less attractive by
attaching tape that is sticky on both sides or a
piece of cotton scented with bath oil to the furniture.
Attach a few
pieces of tape to the edge
of your sofa or other
piece of furniture he loves.
So, I 1)
attached a surface mount thermocouple to the outside
of the twinwall to measure the «actual» surface temperature, and 2) applied a roughly 1.5 by 1.5 inch
piece of blue painters
tape a few inches below the thermocouple — this is the often used technique
of placing a patch
of something with know emissivity over an unknown emissivity surface, and then measure the temperature on the known patch.
I used ceiling tiles, glued them to a
piece of masonite board, covered with a linen fabric and I used duct
tape to
attach it so I could take it off to wash it once a year or so!
We
attached a little
piece of trim with wood glue and painters
tape to the top edge
of the wallpaper border:
To
attach the returns, apply a sparing amount
of liquid nails, position them in place then clamp (I used a picture frame clamp though as the return
pieces are only small you could simply use
tape to hold them in place until set).
Then I made a small banner by
attaching the
pieces to a small
piece of twine using
tape.