The bottom air layer temp did change and became equal to the ground temp, and the temp profile changed, but the top layer temp also remained constant.
Not exact matches
The middle
layer of the wrap is made up of thousands of breathable fibres and the
bottom layer is an open weave, hypoallergenic mesh, full of holes to accommodate maximum
air flow.
My only complaint is that the top
layer of fabric with the design on it must be slightly wider than the
bottom plain
layer because after I washed and
air - dried it, ironing was a pain because the fabric didn't lie flat.
The display has been rendered more crisp and sharp with a lot less glare by laminating the
bottom LCD screen and the touch sensor
layer on top with zero
air gap in between.
Inside a greenhouse, hot
air can rise only so far; so the cold
layer of
air on the
bottom can get heated too.
Changes in convection and cloud formations through altered
air moisture (CAPE) could have implications for the coupled mode mechanisms, as would a deeper thermocline (usually situated near the
bottom of the warm surface
layer).
Brick veneer and the
air space - Harking back to «old - timer» practices — place a thin sand
layer at the
bottom of the 1 - inch
air space (to act as a bond break for mortar droppings) and leave bricks out intermittently in the first course.
This gets ride of hundred of words about about molecules interacting etc Then we get the isothermal case You did not comment on the fact that in the adiabatc case it needs a negligable amount of energy to raise a parcel of
air from botton to top but if your silver wire delivers heat from the
bottom layer to the top
layer the outside work must be done to restore DALR.
One would expect this
bottom layer to be thin and the thermal lapse to be small — the
air above this turbulent
bottom would be nearly uniform in temperature in time.
The evaporative, conductive and radiative processes combined then set up a thermal gradient causing an upward flow of energy from water to
air from where that 1 mm
layer touches the ocean bulk below, up across the cooler
layer then to the Knudsen
layer by reversing the normal (warm at the top and cool at the
bottom) temperature gradient which exists from that 1 mm
layer down to the ocean
bottom.
(1) When the GISS talks about a «Surface Temperature Anomoly» they are not speaking about the surface of the earth, but rather about the tiny
bottom layer of the
air.
Fresh water lakes would freeze from the
bottom if not for the latter property and would freeze solid rapidly because there's no
layer of surface ice insulating the unfrozen water from the below freezing
air above.
These OMITTED / POORLY Represented processes include the following: oceanic eddies, tides, fronts, buoyancy - driven coastal and boundary currents, cold halocline, dense water plumes and convection, double diffusion, surface /
bottom mixed
layer, sea ice — thickness distribution, concentration, deformation, drift and export, fast ice, snow cover, melt ponds and surface albedo, atmospheric loading, clouds and fronts, ice sheets / caps and mountain glaciers, permafrost, river runoff, and
air — sea ice — land interactions and coupling.