The actual Apple logo, which is not pictured here, resembles
the bottom middle panel, but with the leaf facing the other way.
Not exact matches
Examples of the following intervention label formats: traffic light label (top), Health Star Rating label (
middle) and nutrition information
panel (
bottom).
Retinols labeled at Mretinol + 5 or Mretinol + 10 (Mretinol = m / z 268, representing unlabeled endogenous retinol) were detected in serum extracts, as shown in the
middle and
bottom panels of Figure 5.
The mass distribution of circulating retinol at baseline (day 1 at 0 h before the reference dose; top
panel), the enrichment of Mretinol + 10 = m / z 278 from the reference dose [13C] retinyl acetate (day 1 at 13 h after the dose;
middle panel), and the enrichment of Mretinol + 5 = m / z 273 and Mretinol + 10 = m / z 278 retinol (day 9 at 0 or 24 h after the Golden Rice meal;
bottom panel) are shown in the figure.
Next, you will create a «V» shape with the prefold diaper by pulling the already folded
bottom, left corner to the
middle (center
panel), and then repeating it again on the opposite side.
You can save a little fabric for the waist straps if you don't cut the two body
panels apart in the
middle (that would be the vertical line between the two, in the diagram above), and instead fold it in half — the fold can then be your
bottom edge, since the waist straps will be put in horizontally, and that'll save you a couple of inches.
Wild potatoes from the Peru and Chile (top and
middle panels, respectively), and cultivated European potatoes (
bottom).
For each gene, the top
panel presents the unmethylation - specific bands (UMSB), the
middle panel presents the methylation - specific bands (MSB), and the
bottom panel presents the mRNA expression levels (mRNA).
In all «aborted» clones, cells were generally big and flat (e.g., Fig. 2B,
bottom middle and right
panels) and SA - βgal positive (not shown).
In back, a symmetrical embroidered lace
panel in Ivory delineates the
middle of the back and finishes the
bottom of the solid knit back side
panels.
The top
panel shows the returns, the
middle the absolute yields, and the
bottom spread versus treasuries (click to enlarge):
The right - hand
panel shows ranges of global average temperature change above pre-industrial, using (i) «best estimate» climate sensitivity of 3 °C (black line in
middle of shaded area), (ii) upper bound of likely range of climate sensitivity of 4.5 °C (red line at top of shaded area)(iii) lower bound of likely range of climate sensitivity of 2 °C (blue line at
bottom of shaded area).
The values in the
middle panel are added to the red record in the top
panel to give the blue record in the
bottom panel.
Figure 2 shows the observed precipitation anomaly (top
panel), the model generated precipitation anomaly with SST forcing only (
middle panel), and the model generated precipitation anomaly with the effects of observed SSTs and the added dust source (
bottom panel).
Shown are data from the Global Historical Climatology Network (GHCN) dataset and output from the two GISS model experiments (SST only in
middle panel and SST+D ust in
bottom panel).
Relationships between δfoF2 (top
panels), δfoF1 (
middle panels) and δfoE (
bottom panels), and Ap132 variations for Slough (left
panels) and Rome (right
panels).
The top and
bottom panels, from Petty, peak at 15μm to 20μm, while the purple, blue, and black curves in the
middle panel, and the Earth System curves from the Carleton spreadsheet I used (see above) peak in the 9μm to 11μm range.
The amplitude of each fingerprint that is consistent with data is estimated as a distribution of «scaling factors» (top
panel in Figure 5), which when multiplied by the raw model results yields a distribution of the contribution of each forcing to the total observed anomaly (
middle panel) and a residual variability notexplained by forcings (
bottom panel; see also Figure 1,
bottom panel and Hegerl & Zwiers, 2011 for more detail).
At the core of the redesign lies the decision to remove the physical Home button usually found in the
middle of the
bottom panel.
Partner presence by attachment avoidance interaction effects for pain rating (top
panel), N2 local peak amplitude (
middle panel) and P2 local peak amplitude (
bottom panel).
2) did you find that the boards in the
middle stick out a smidge since they're up against
panel while the top piece and
bottom piece are fixed directly to the wall?
Then I took that full shower curtain with the new
bottom attached, and I cut it in half right down the
middle to make two
panels.
The top
panel will be 6/10 and the
middle and
bottom panels will each be 2/10 of the total measurement.
Add 1 inch total to the measurement of the height of the
middle panel for seaming it to the top and
bottom panel.