2 Using scissors,
cut ribbon lengths in half to form eight 6 inch lengths.
Not exact matches
Next, I
cut a
length of
ribbon, wrapped it around the pot (near the top), and tied a tight knot.
Cut two long
lengths of
ribbon (twill tape, grossgrain, anything will work) and place in the center of one side of the opening.
A favorite game recently was for each guest to
cut a piece of
ribbon to the
length they believed the expecting mothers belly circumference would be... it was fun and funny... prego has to have a sense of humor due to some «slightly» over sized guesses haha:) closest to actual size won a prize...
A few buttons,
ribbon cut to
length, plus some embroidery thread in an off - setting color makes for a simple yet stylish bracelet.
To make ornaments,
cut wide grosgrain or satin
ribbon into 8 - or 10 - inch
lengths.
Cut a
length of wired
ribbon (about 3 to 4 feet) and use it to form a candy chain by winding the
ribbon around the wrappers (where they twist shut) or sticks.
To make the burlap
ribbon rose, I
cut off a 24 inch
length of
ribbon.
Cut a
length of
ribbon long enough to fold both sides in at a 45 degree angle.
eShakti Women's Ditsy floral print cotton piped dress A ditsy floral print enlivens our flattering fit - and - flare dress
cut from lightweight cotton and framed in contrast piped trim, Back zip with hook - and - eye closure, Scoop neck, split front with
ribbon ties, Elbow
length sleeves with bead - button closures at cuffs, Princess - seamed bodice, Banded waist, Ruched pleat full skirt, Side seam pockets, Below knee
length, Lined in light cotton voile, Cotton, woven cambric, lightly sheer, no stretch, lightweight, Machine wash cold
Cut a
length of
ribbon and loop it through the wreath.
I also decided to
cut long
lengths of black satin
ribbon to tie around the ankle, so the sandals look a bit more like the ones Off - White shows with the socks.
And
cut lengths of 5/8 ″ jute
ribbon which I pinned along the seam and sewed on to serve as ties...
Each piece is based on simplified geometric forms, made from Laser
cut and engraved perspex.This necklace is also supported by jump rings (for the perfect fit) and ties up with a black satin
ribbon that can be worn at various
lengths.
Cut quite a few pieces of
ribbon a similar
length.
Simply print,
cut, fold and stick each flag onto a
length of string or
ribbon and display.
Bardel Bows offers fascinators — streamers of
ribbon that can be used alone or attached to bows and
cut to the
length desired — and Knight suggests using them to increase awareness of the causes your business supports.
Cut a
length of
ribbon and put a dot of hot glue on the bottom of the pinecone in the center.
Cut decorative
ribbon to determined
length and loop the
ribbon through the wreath at the top.
Things to do: * measure the
length and width of the backrest * make the pattern on the red fabric as shown on picture *
cut the white fabric with 2 inch wide, stitched them * tie the white
ribbon with abstract patterns, and sewing at the tip red fabric
To make a garland, I used black straws which were
cut in 3 inches in
length and then I looped through each
cut piece a golden
ribbon.
Instructions:
Cut a strip of fabric the
length and 4 times the width of your desired finished
ribbon length and width.
I wanted my pinecones to be somewhat staggered in
length, so I just kept holding the glued pinecone +
ribbon up to figure out what
length to
cut my next piece of
ribbon.
Just
cut the
ribbon to 5 inches in
length (or at least long enough to overlap the small inner loop by about an inch on each side).
Cut a small piece of felt about an inch wide and the same
length as the ornament and glue over the spot where the
ribbon joins the ornament.
Match the
length of the
ribbon to that of the finished floral fabric strips, moving the bead as necessary, tie a knot under the bead and trim off the excess
ribbon with a diagonal
cut.
Step 1) To make a 70cm - square curtain,
cut five 10 cm by 80 cm strips of floral fabric, four 80 cm
lengths of voile
ribbon and five 80 cm
lengths of ric rac braid.
Now just
cut a
length of
ribbon so your wreath hangs at the height you want.
Cut 10 pieces of grosgrain
ribbon into approximately 12 - inch
lengths.
To make the ornaments,
cut a 10 - inch
length of
ribbon, fold it in half, and attach the midpoint to a walnut with a hot - glue gun.
Measure across your mirror, and
cut a
length of
ribbon double that measurement; tie the two ends together.
Cut lengths of coordinating fabric and add
ribbons to create a custom garland perfect for parties, birthdays, mantel decorating and more!
Then I
cut a short
length of 1/8» Daffodil Delight Taffeta
ribbon and inserted it through the holes of a blue button from the Brights Designer Buttons.
One last Pinners class trivia: We
cut 100 yards of
ribbon into 9 and 18 inch
lengths.
Material • X-Acto knife or kitchen knife • Metal ruler • Self - healing
cutting mat • 3 beeswax sheets (8 by 16 in / 20 by 40.5 cm), in shades of blue for Hanukkah or colors of choice for other holidays • 6 yd / 5.5 m cotton square braid candlewick, size 3/0,
cut into 4 1/2 - in / 11 - cm
lengths • Paper plate • Nonflammable silver glitter for Hanukkah, or color of choice for other holidays • Sheet of tissue paper parchment paper •
Length of
ribbon