Once these were dry,
I cut tails shapes out, and glued tails onto the back of the mice.
Not exact matches
While today they are made in various
shapes and sizes, at one time the dough was baked in a round mold and then
cut into wedges that were given the name «petticoat
tails».
From the same remaining 6 - inch cake round, use a knife to
cut a face
shape - I just made an even
cut to make a flat edge on the side of the cake round where I had
cut the bunny
tail, and then
cut at the same angle on the other edge of the cake round.
Now
cut out triangle
shaped tail fins for your fish and glue both the
tail fin and buttons onto your paper to make all of your fish.
The C -
shaped tail lamp assembly and the prism
cuts on the boot carry forward the family trend and all new models from Skoda will imbibe the same design language.
Without letting go of the trimmed
tail, but dropping your hold down about an inch or slightly more, begin using the thinners to trim the
tail so that it looks like a half of a pom - pom, by angling
cuts from the sides to the center, leaving the pom - pom a little «higher» in the center, i.e. a nice ROUND
shaped tip of
tail.
Standard Lorentz line
shape gives far too strong absorption, and it's essential that the far
tails are
cut off correctly.