Sentences with phrase «damaged wheel bearing»

A roaring sound while decelerating can be caused by a damaged wheel bearing or in some cases an exhaust leak.

Not exact matches

You should check the tire screws, drive shaft, wheel bearing and the tire itself, if you can't see any external damage or anything bad I would suggest you keep driving and check if the noise will get quieter soon.

The only way I can see there being a problem here is if there was actual damage done to the torsion suspension portion or to the wheel bearings themselves.

Bumping a front wheel this way can cause damage to your Inner Tie Rod, Outer Tie rod, Hub Bearing, CV Joint, and CV Boots.

You may have damaged the wheel hub or wheel bearing, which could allow the rotor to rub on the pads.

The first time this happened, I took it back to the shop that replaced the wheel bearings and they found that the speed sensor on one of the wheels had been damaged during wheel bearing installation and they replaced that speed sensor.

The first time this happened, I took it back to the shop that replaced the wheel bearings and they found that the speed sensor on one of the wheels had been damaged during wheel bearing replacement and they replaced that speed sensor.

One thing you might want to check is your wheel bearings, as damaged or loose wheel bearings can cause a «floating» issue with the front end that tends to clear up when braking...

As the bearings begin to wear out or become damaged, they impact the wheels ability to spin smoothly, freely, and securely.

What you are describing is commonly associated with damaged or faulty wheel bearings (https://www.yourmechanic.com/article/symptoms-of-bad-or-failing-wheel-bearings).

We greased up the wheel bearings and seals to make sure they would not be damaged when we installed the new rear axles.

Driving fast over speed bumps can damage your struts and other suspension components, as well as the wheel bearings and rims.

All internally lubricated parts: Front or rear drive axle housing and all internal parts, pinion bearings, wheel bearings, side carrier bearings, ring and pinion, gears, spider gears and case, thrust washers and spacers, housing only when damaged by an internally lubricated part covered by the contract.

• Examine existing tracks to determine need for repair and maintenance and provide feedback to the supervisor • Clear sites by removing debris and hazardous materials to make them ready for new track installations • Install new tracks by laying and fixing foundations and sleepers for tracks • Cut rails to appropriate lengths prior to installation and ensure that they conform to set standards • Remove damaged rail parts and ensure that new ones are installed within given timelines • Maintain switch signal lamps and wheel bearings of rolling stock and assist with righting of derailed rolling stock • Inspect tracks for defects using a variety of tools and equipment, as well as sight checks • Carry out site surveys to identify maintenance needs of track sections

• Track record of efficiently preparing worksites by removing hazardous materials and debris • Proven ability to fashion track lengths according to set standards and specifications • Hands - on experience in inspecting tracks to determine need for repair and maintenance • Familiar with replace, remove and repair tracks and related components to ensure smooth railroad operations • Effectively able to handle drilling duties to insert bolts and joints and perform preventative maintenance on tracks and components • Highly skilled in gauging deviations in track surfaces and performing related repair work to ensure train safety • Exceptionally well - versed in operating picks, shovels, bulldozers and spike - driving machines to meet rail track repair, maintenance and installation needs • Deep insight into inspecting tracks for defects and reporting and clearing potential obstacles, especially after bad weather • First - hand experience in performing lookout and hand signaling duties during track operations such as installation and maintenance • Competent in laying and fixing foundations and sleepers for tracks, cutting tracks to lengths and installing railway switches • Qualified to remove damaged rail track parts and examine and maintain switch lamps and wheel bearings