«The architectural focal point in the living room is its ceiling, with wooden beams mounted on a 45 -
degree angle over white beadboard.
Heels should be far enough away from the wall so when you lower to a down position you're knees are at a 90
degree angle over your heels.
I would recommend using a 15 - 30
degree angle over flat bench presses in most cases.
Not exact matches
I'm an atheist, too, and I find displays of religion as a response to an attack motivated by religion somewhat ironic (though not quite as perverse as stepping
over 2500 dead bodies to find a 90 -
degree angle and then hoisting it up and saying «see, god is here!)
Fist - pump at a 45
degree angle, half between the sky and the fans in the stands to indicate «Gee, I'm so glad God is up there and I'm so glad those fans are
over there»?
Light is sent through an array of small lenses — which refract it
over a viewing
angle about 50
degrees wide and 20
degrees high — and through an LCD screen that carries part of the final image.
This changed the refractive index to a differing
degree across the metamaterial, allowing it to mask a bump in a gold foil
over a wide viewing
angle of about 60
degrees.
The 14 - inch - long prints Freeman showed him were interesting, Meldrum says, because some turned out at a 45 -
degree angle, suggesting that whatever made them had looked back
over its shoulder.
This means that you will have your body bent
over at a 90
degree angle when you're doing reps with just a little amount of weight, but you should bend your body only to a maximum of 45
degrees when you're lifting heavy weight.
Start by taking one large step forward and lower your body so both of your knees form 90 -
degree angles, keeping your front knee
over the ankle.
Make sure your right knee hovers
over the floor, and your left knee forms a 90 -
degree angle to the floor (d).
As you come up out of the squat, press your hand weights up
over your head to a full extension while kicking one leg out to the side at a 45
degree angle.
When you're first starting out with hanging leg raises, which means you have never done them before or haven't done them properly, then you shouldn't worry about going
over a 90 -
degree angle.
Bring hands to the floor and come into a single - leg plank, with right foot on the floor and left leg bent
over right at a 90 -
degree angle, foot flexed (A).
- Bend both knees to about 90 -
degree angles, keeping the knees aligned directly
over the feet (not rolling forward).
Lie on an incline bench adjusted to an incline
angle of 30 to 45
degrees, holding a pair of dumbbells
over your chest with extended arms, with a slight bend at the elbows.
After that I'd switch
over to the one leg variation on either a parallel or 45
degree angled bench.
Bend
over at the waist until torso parallel to floor or at 45
degree angle, abs in and knees slightly bent.
Bend
over at the waist until the torso is parallel to floor or at 45
degree angle, abs in and knees slightly bent.
Plant your left hand firmly against the ground at a 90
degree angle, and push yourself to the right so that your body goes up and
over the roller.
Inhale and create space in your torso, and on an exhalation bend your left knee to a 90 -
degree angle, left thigh parallel to the floor, with the knee
over the ankle and in line with the second toe.
Now, I step out exaggerating on a 45
degree angle, and I land with my head
over my foot, and now position 3 turns into position 1 on the other side.
The movement starts with the dumbbell
over your chest, elbows bent 10 — 15
degrees (do not let this
angle change throughout the entire movement)
Lift your arms
over your head and lean slightly forward so that your torso and thighs make a 45 -
degree angle with each other.
Bend the right knee to a 90 -
degree angle, keeping the knee aligned directly
over the ankle.
Bend your right leg to a 90 -
degree angle, knee aligned
over the ankle.
Bend
over slightly at a 45 to 65
degree angle with a slight bend in your knees.
Legs: Front - knee bent at a ninety -
degree angle, knee
over ankle.
Beginning from modified high plank with shoulders
over elbows
over wrists and knees on the mat, exhale and lower down until the elbows are at 90
degree angle.
Make sure that the hands are far enough away from the face to create Chaturanga arms — elbows
over wrists, full ninety
degree angle in elbows.
Sit in a chair with your shoulders
over your hips, legs bent at a 45 -
degree angle.
Day 2 - Shoulders, Legs, and Abs Military Press Barbell Upright Rows Bent
Over Lateral Raises On Incline Bench Squats Lunges (press with toes) Leg Extensions Stiff Legged Deadlifts Leg Curls Calf Raises Sit Ups (Go up to a 30
degree angle only) Leg Raises Swiss Ball Crunch Knee Ins
Step forward into a lunge with your right foot in front, knee bent (as close to a 90 -
degree angle as possible) directly
over your right ankle, hips square to the front.
To perform one type of seated calf raise, position the pad
over your thighs to grip you snugly with your knees bent at a 90
degree angle.
Rules to sit by: Line up head
over shoulders and shoulders
over hips, rest on your «sitz bones» (the two bones in your rear end), and place feet flat on the floor with legs at a 90 -
degree angle.
You can drive your bike at a ninety
degree angle and not fall
over.
Above that it raises to an
angle of one
degree to increase pressure
over the rear axle and help stability.
The Raptor boasts an approach
angle of 32.5
degrees, a departure
angle of 24
degrees, and a ramp
over angle of 24
degrees.
Haval lists the H9's approach, break -
over and departure
angles at 28, 23 and 23
degrees respectively.
Ground clearance increases by a quarter of an inch, maximum fording depth increases by four inches to
over 27 inches, and
angles of departure, approach, and break -
over all increase by one
degree.
Slow things down by leaving two - lane gravel back roads for trickier pathways and the Evoque's off - road quality shines more, its systems deploying effectively to maximise traction and bringing its 18.5 -
degree approach, 22 -
degree break -
over and 30 -
degree departure
angles to the fore.
For those heading off - road, the T60 4 × 4 offers good approach and departure
angles of 27.1
degrees and 24.5
degrees respectively, but the ramp -
over angle is negatively impacted by the that considerable length.
A dial on the dashboard lets you set them between five
angles, allowing a fine
degree of control that's mostly useful if you expect to slog the car
over hill and dale at night.
The Tacoma Off - Road package affords drivers just
over 32
degrees in approach
angle, a 21 -
degree breakover
angle, and a 23.5 -
degree departure
angle.
Double - wishbone suspensions allow for more control
over the camber
angle of the wheel, which describes the
degree to which the wheels tilt in and out.
The B1's break -
over angle measures 33
degrees, meaning the electrified SUV can straddle fallen logs and sharp rocks with less risk of getting beached.
The Jeep's short wheelbase is also partly responsible for its level of capability, a breakover
angle of 22.9
degrees gives the Cherokee the ability to crawl
over the crest of steep hills without getting high - centered.
But it rarely scraped its belly, thanks to a second highest approach
angle (30.1
degrees), third - highest break -
over angle (22.6) and second - highest departure
angle (25.1).
The Everest offers 225 mm ground clearance and a 21.5
degree break -
over angle (second worst to the Wrangler).
While sporting the highest approach (35
degrees) and departure (28
degrees)
angles in the group, it was let down by the lowest break -
over angle of the group (18
degrees) and unimpressive ground clearance (220 mm), resulting in more than a few scrapes
over the moguls.