It is capable of reading and clearing both generic and
manufacturer diagnostic trouble codes and performs I / M testing to quickly and efficiently determine the cause of the check engine light.
Clears all trouble codes and complete sa test drive to see if the
P2281 diagnostic trouble code comes back (if so, completes a test of the MAF, MAP and IAT sensors using the manufacturer's instructions
P0420 dtc code catalyst system efficiency below → P0420 dtc catalyst system efficiency below threshold → P0420 catalyst efficiency below normal engine misfire → How to test p0420 obd ii trouble code (gm 3.1 l, 3.4 l) → Part 1 how to test trouble code p0420 (gm 3.8 l) → Code p0300, p0301, p0302, p0305, p0306, p0420 gmc acadia → Mercedesbenz dtc fault code list → Jeep grand cherokee wj
diagnostic trouble codes → Check engine light codes [obdii dtc] → 2000 toyota camry my check engine light is on.
The
P2403 diagnostic trouble code is not generally considered serious because there are usually no visible symptoms present during operation of the vehicle.
Clears all trouble codes and completes a test drive to see if the P2281
diagnostic trouble code comes back (if so, checks the MAF sensor for dirt and debris and clean the MAF sensor as necessary)
These services include Automatic Collision Notification, Enhanced Roadside Assistance, Automatic
Diagnostic Trouble Code Notification, Monthly Vehicle Health Report and in - vehicle Car Care Maintenance Scheduling.
Read and
clear diagnostic trouble codes (DTCs) such as confirmed, pending and permanent check engine codes, Enhanced Codes (e.g. ABS, Airbag, Transmission, etc.) and more.
The most common causes of
Diagnostic Trouble Code P2118 are failure of the throttle actuator control motor, a failed pedal position sensor, a faulty throttle position sensor, an open or short in the actuator circuit, or a poor electrical connection...
These services include Automatic Collision Notification, Enhanced Roadside Assistance,
Automatic Diagnostic Trouble Code Notification, Monthly Vehicle Health Report and in - vehicle Car Care maintenance scheduling.
Viper SmartStart also works with your smartphone, and the version 4.0 update brings easier - to - use speed alerts that can alert you when young drivers exceed the speed limit, and notes and explains
diagnostic trouble codes when your car runs into issues.
If you're driving a pre-1995 vehicle with OBD I, the check engine light is lit by the MAP
sensor diagnostic trouble code: 33 (Manifold Absolute Pressure Sensor Circuit High Signal) or 34 (Manifold Absolute Pressure Sensor Circuit Low Signal).
Diagnostic Trouble Code P0170 means that your engine computer (PCM) has had to adjust the fuel trim (fuel supply), high or low, but to the extent that the adjustment is out of the «normal» range.
To
resolve diagnostic trouble code P0089, the mechanic would test the fuel pressure regulator, check for a clogged fuel filter or screen, check for restricted fuel lines, and test fuel pump output.
Diagnostic Trouble Code P0008 sets when the engine control module (ECM) detects an out of range variation in the mechanical timing of the crankshaft and the camshaft.
Diagnostic trouble code P2004 signifies a problem with a segment of the engine's air intake and control system, technically known as the intake manifold runner control (IMRC).
Diagnostic Trouble Code P0340 will set if camshaft position sensor circuit wiring is broken, shorted, or corroded; a camshaft position sensor circuit connector is broken, shorted, or corroded; there is a faulty camshaft position sensor; a failed crankshaft position sensor; or a faulty PCM (rare).
If you are referring to the warning light for a loose gas cap loose and / or
Diagnostic Trouble Code P0442, a loose or defective gas cap is merely one possible reason for the warning light or the Code.
The
P0882 diagnostic trouble code is an indication that there is an issue with the transmission control module power input signal, which is not likely to prevent the truck from starting.
It is important to determine whether cleaning the MAF sensor and repairing vacuum leaks will resolve the P2281
diagnostic trouble code before replacing the MAF sensor.
Diagnostic Trouble Code P0745 refers to out of range voltage at a solenoid - operated valve that regulates hydraulic pressure in the transmission based on outputs from the Transmission Control Module (TCM).
P0463 OBD - II Trouble Code: Fuel Level Sensor Circuit High
Input Diagnostic Trouble Code (DTC): P0463 P0463 code definition When the powertrain control module (PCM) gets an input signal from the fuel...