Sentences with phrase «drilling small holes»

Reversing cabinet hinge position may require pre drilling small holes.

Install furniture feet on the bottom of the piece by drilling small holes and fixing them in place with epoxy.

Build your insulated compost cans by drilling small holes in larger plastic garbage cans for air ventilation.

Drill small holes along the length of the paint stick 1/2 ″ apart, using a jig saw cut the edge of the board to meet the holes.

When the paint is dry, drill a small hole on each side of each shape.

Drill small holes into the tops of plastic egg halves, and insert a string light into each one.

You drill a small hole that the screw tip of the puller grabs and it then pulls the plug out.

Drill a small hole and run the cable through to your factory backup camera connection.

Drill a small hole and connect the camera harness to the OEM conversion harness.

It's as simple as drilling a small hole behind your license plate to connect the camera to the transmitter, and then connecting the transmitter to the reversing lights» power source and placing the small transmitter in the trunk.

Drill a small hole in the plastic to allow the two wires to exit the back of the radios panel when reassembled.

«Border inspectors don't have to have any reasonable suspicion of wrongdoing to inspect your gas tank, drill a small hole in the bed of your pickup truck or remove car door panels.

I have drilled a small hole in the bottom of a cabinet and poured some in then caulked it closed.

Should I drill some small holes before laying down the landscape fabric?

We pre drilled a small hole and then screwed the hook in, and on the inside of the cabinet the hook is held up by a washer and a nut.

Drill small hole into top and place tie wire you can get at any home improvement store.

We drilled a small hole in the back for phone chargers and added this phone organizer we already were using and a spot for pencils, and change.

3 Drill a small hole into the back centre of each can.

Not exact matches

The zinc target tested in these short drill holes is one of two or more zinc zones in the area near some historic small scale mining on the Mountain View mine property that occurred nearly 50 years ago.

We (meaning Derek, I just stood there and took pictures), measured out the desired distance and drilled a pilot hole, which is a small guiding «starter hole» before you start putting holes in your grill lid with a giant drill bit.

In this case, in a 10 - hour - long neurosurgery, two small holes were drilled in the man's skull, and two electrodes were placed in his central thalamus in a region that is thought to influence overall arousal levels and that connects to other regions relating to movement and motivation.

What It's Made of: An array of giant concrete cylinders, 60 to 200 feet in diameter, each drilled with small holes to manipulate seismic waves.

He then seeded the cells on a polymer scaffolding, infused them with apatite (a mineral component of bone), and injected the mix into small holes he had drilled into the animals» skulls.

Small laser - drilled holes on the abluminal stent surface control drug elution.

Drill a few dozen small holes, spaced a few inches apart, along the bottom and sides of the bin — these will help with drainage and aeration.

We (meaning Derek, I just stood there and took pictures), measured out the desired distance and drilled a pilot hole, which is a small guiding «starter hole» before you start putting holes in your grill lid with a giant drill bit.

Cut or drill a hole in the bottom, throw in some small rocks to help with drainage, add your soil and plant, and you have yourself the cutest table topper of all time.

I started by drilling two small holes through my acorn tops, which gave me a way to hang them.

Once the hole has been drilled, apply a small amount of silicone caulk to the edges of the opening.

The next step is drilling very small holes in the prototype in preparation to create a mold.

Do they drill holes when repairing windshield stone chips that have small cracks?

Drill a couple small holes in the bed as well, then cover the freshly cut holes with some body matching paint.

On the opposite end of the connecting rod, a smaller hole is precisely drilled.

The former are now covered by small drilled holes, rather than one large opening, while the latter is a replacement for the wide, 30 - pin dock connector of old.

There's also the small matter of a massive drill digging a hole in Seattle that released volcanic gases that turns people into zombies.

It is made using the 13 Chopsticks, a drill (to make a small hole), a bolt (to keep these sticks stable and intact) and some wooden glue (to stick them together).

Use food - grade PVC pipe, buy 2 end caps (make one side a screw top so you can easily clean), drill 1 or 2 small holes just a bit bigger than your dog kibble, and fill with kibble.

In these playful, environmental works, such as spinach and banana (2013), Estna arranges her paintings in various positions, tilting them against walls, hanging them, and placing them on their sides; she often extends patterns to fabrics heaped on the floor and small spheres placed on pedestals, or drills holes into canvases so that light shines through them.

After the wells on a pad are drilled, cased and cemented, a device perforates the horizontal part of the production pipe to make small holes in the casing, exposing the wellbore to the shale.

Drilling equipment is used to bore small — diameter holes from depths of 60m to 120m (200 to 400 feet) deep.

Quite impressive, though I wouldn't go as far as to compare it with the few Tesla Model S fires (which I put in context here) because the situation is quite different, with only one cell getting relatively low - energy impacts over a small area compared to a whole battery pack getting a high - energy impact from a large piece of metal debris or a brick wall or whatever, and on top of that, in one of the fires the firefights drilled holes in the battery, which made things more spectacular than they otherwise would have been.

If your exterior is wood, all you need to do is drill pilot holes using a drill bit that's a tad smaller than the included screws.

I drilled a pilot hole (a hole drilled through the board that is smaller around than the screw) through the 2 × 3 before screwing them to the wall.

Big and small hooks, bins, shelves and more fit into the panel's grooves and can be moved around, maximizing the system's flexibility and eliminating the need to drill a new hole every time you buy a tool.

I just drilled a hole directly across the top with a small bit.

If the eye hook does not screw in easily you can start a small hole in the top with a small drill bit.

I actually had to use a couple drill bits because I stared out too small, but I'd much rather have to move up a size or two than have a huge hole!

Find a tree trimming service that would give you small branches, slice and drill holes!

Next, we drilled a hole in the wall (a little smaller than the dowel) where we wanted to hang the propeller...

I'm thinking you could actually use potted flowers, and place a small drainage tray inside, instead of drilling holes?