Sentences with phrase «edge of the board»

First, measure the inside edges of the board.

Building the top was genius, love the round top and how edges of boards look too.

Adhere to the outer edge of the board with wood glue and secure with your air nailer or small finish nails.

Photo paper mounted on mat board, faded, edges of the board chipped, 27 1/2 x 21 1/2 in.

You'll find headphone and microphone jacks along the top edge of the board just above the number pad as well as a single USB 2.0 pass - through port.

For laminate flooring, choose designs with V - grooves along the long and short edges of the boards, and with textured surfaces, which look far more realistic than completely smooth surfaces.

Usually, the crooked edges of the boards create the gaps naturally, so you can really just butt them up together... usually!

With light brown icing pipe the outline of the turtle and pipe all around the edges of your board.

• Place the two binder covers on top of one another and «rubber band» them together by stretching a rubber band around each end, about 2.5 centimeters from the edge of the boards.

Rotate the wobble board in a circle but do not allow the edge of the board to touch the floor.

Rotate the wobble board round so that the edge of the board is in contact with the floor at all times.

See how I continued the stripes around the edge of the board on both ends?

Groove around the edge of the board collects excess juices from meats, fruits, and vegetables to eliminate countertop messes.

I began by rubbing the edges of my board with a clear votive candle.

Drill small holes along the length of the paint stick 1/2 ″ apart, using a jig saw cut the edge of the board to meet the holes.

Like a diver whose going to jump off of the diving board backwards in an infinity pool of beauty and peace, step to the edge of the board, take a deep breath and dive energetically backward into oceanic space of your kindness.

Generally, you're introduced to a new hazard at the beginning of a stage, like deadly Line Chasers that patrol the edges of the board, or Homers that latch onto you and reduce your speed to a crawl.

Gamers must ensure lines don't run into the edge of the board or each other, and will earn up to three stars on each stage, depending on their performance.

The Wii Fit board is a little like a smart weighing scale, able to tell your balance and position using sensors at each edge of the board.

For me, abstract painting's completely spontaneous — the only borders are the edges of the board or the canvas.

At the edge of the board there are some clips securing the board in place, so you need to lift up the board close to the battery.

Laminate flooring with V - grooves along the edges of the boards and textured surfaces are worth the extra cost as they look more realistic than a completely smooth surface.

Inexpensive DIY store versions may look flat and lifeless, and the «wood» finish may flake or chip at the edges of the boards.

Then I brushed it along the edges of each board, using slightly firmer pressure.

Use a fine grained sandpaper to distress the finished sign by removing some of the all over paint color on the front and edges of the board.

After her eldest drilled pocket holes and screwed them into the wall, the youngest sanded down all the edges of the boards.

I just staple gun garland to edge of board, plop the board onto the mantle, and place all the other decor on top of it.

Then you can use your scissors along the edge of the board to trim the adhesive.

Find a spot near the edge of the board that isn't damaged (or above a cable or pipe) and drill a hole.

The edge of the board provides a square surface to which the crown moudling can be applied.

Start on the edges of the board and concentrate on the molding and use long even strokes.

- Make sure that you place it in the middle of the edge of the board.

Once dry, attach to the edges of the board with wood glue.

I painted the wall and the edges of the boards as I was going so that the gaps were the same color as the boards (white in this case!).

Did you use a finishing trim to conceal the edges of the boards, or just sand them a bit, paint, and leave them exposed?

Secure the pieces at each end on the edge of the board with map pins, pulling them taut and allowing enough ribbon to overlap to the back of the board.

Then remove the map pins from the edge of the board and insert them into the front of the board at the point s where the ribbons cross, pushing them all the way in.