Sentences with phrase «edges of frame so»

Step 2) Fold the fabric around the side edges of frame so that it overlaps in the middle by around 5 cm, open out again and mark this third cutting line.

Not exact matches

Though the 1.85:1 anamorphic widescreen transfer of the film (full - frame version sold separately) starts out looking scuffed, the speckles clear up after the opening credits — but then edge - enhancement intrudes, and there's a bizarre lapse in quality during chapter 6, when intermittent shots lose so much definition as to suggest second - generation VHS.

The metal sides offer good grip and we like how the glass blends seamlessly with the frame so you don't feel any of the edges.

Time has gone into painting the edges of the boxed canvasses so that framing is not necessary and can be hung as is.

Michael Fried argued in Three American Painters (1965) for the importance of «deductive structure,» where elements inside the painting are echoes of the framing edge and so create an intensified unity.

«This is so despite the fact... the forms do not extend all the way to the edge of the canvas;» they are not cropped by the frame the way the horizon is in conventional landscape painting.

Horizontal pencil lines perhaps half an inch apart are ruled to the edges of a framing border of bare canvas two inches or so on all four sides.

Estimate $ 4,000 - 6,000 Due to extensive framing, the print can not be examined out of the frame, but it is floated so the edges are visible.

The small works we framed right to the edge because the edge of each collage is a thoughtful decision about space; and yet there is so much going on that to verbally describe one 8.5 x 11 drawing would take paragraph after paragraph.

Kuo maintains, however, that it is still not possible for Apple to release iPhones with all - glass casing at this point, so the tech giant could be looking into using metal frames to surround the edges of the front and back glass casing for «reinforced structure design.»

When holding the phone in landscape mode with the home button and charging port facing to the right, the bottom - facing speaker sits on the top edge of the bottom part of the frame so it's mostly unobstructed, and this makes the sound a little easier to hear without having to turn up the volume.

Step 3: Take candle wax and rub it on the edges of the piece of furniture you're distressing and any other areas that you want to distress, this will make the distressing process so much easier (Sorry I don't have a picture for this step) but you can check out my DIY Distressed picture frame tutorial if you want to see what i'm referring to)

Step 3: Create templates of all your frames Step 4: Label templates Step 5: Measure the area where you want to create your display and mark centre point Step 6: Start at the centre and work outwards Step 7: Tape your templates to the wall so you can use it as a guide Step 8: Use a spirit level to ensure it is straight Step 9: Repeat & tape up other templates measuring spaces in between Step 10: Measure distance of nail position from edge of frame Step 11: Measure and mark nail position on each template Step 12: Hammer nails in place Step 13: Remove templates Step 14: Hand your pictures

But I just ignored that and had my local glass cutter cut a mirror to fit the entire 16 inches of the frame so the mirror would be behind the cutouts all the way to the edge, and had the mirror glued to the back.

Especially with a frame that will hide a big chunk of the edge so it is very forgiving.

Photography courtesy of Ryan Brook / TC Media Cleaning products A sturdy squeegee with a metal frame and quality rubber edge is a must; so is a pole attachment for any out - of - reach windows.

This is where the face of the mirror frame will rest, so measuring from outside edge to outside edge should equal 5 1/2».

Place the 1/4 x 3 trim pieces on the frame so that the shorter pieces set between the longer pieces and flush with the edges of the frame, as shown.

Allow a small inset (1/16 ″ or less) from the top of the shelf (3/4 ″ ply) to the edge of the frame (1 × 2) of the bottom shelf, so that when you attach the screws, it doesn't go through all the way.

The cabinets are meant to be stacked on top of each other, so mine was missing a top, but it already had a nice wood frame around the edges that I could easily attach new boards to.