Sentences with phrase «efficiency at low loads»
MPI allows for earlier mixing of air and fuel to increase engine efficiency at low loads.
http://www.greencarcongress.com/ Not exact matches
The result is enhanced efficiency under low - load conditions, such as at idle or highway cruising, and increased power for brisk acceleration or times of high demand
By reducing valve opening at low speeds and loads, Intake Valve Lift Control helps reduce power wasted internally, thus improving fuel efficiency.
By operating the engine at higher load and at lower rpm, optimal efficiency can be obtained.
Additionally, the 2.4 - liter Tigershark features a two - stage oil - pressure relief system that reduces engine - oil pumping loads at low engine speeds for greater fuel efficiency.
Unlike a conventional compressor which can only operate at 100 - percent and must be switched on and off frequently to conserve fuel when the cooling load is relatively low, the VDC can vary its output based on the cooling needs, resulting in greater efficiency, reduced drag on the engine and smoother climate - control performance.
The Direct Injection Gasoline (DIG) system improves combustion efficiency and performance, and enables the engine to avoid knocking at higher compression ratios, while the multi-point injection mixes fuel and air earlier, enabling complete combustion in the chamber for greater efficiency at low engine loads.
At low engine speeds and loads the pump's flow can be throttled back, for example, cutting the power required to drive it and improving overall efficiency.
Oversize engines designed to operate at low working loads with high efficiency, producing less engine noise and vibration at normal cruising speed.
In passenger cars at low partial loads, a higher swirl level (partial closing of the filling port in a four - valve cylinder head) can lead to a better particle / NOx trade - off, whereby consumption as well as CO emissions increase because of the deterioration in volumetric efficiency [1].
-- the remaining fossil generators have to be run at lower average loads which lowers the efficiency and reduces life time.