An
electric sander is a power tool that helps smooth or remove materials such as wood or paint by rapidly moving a sandpaper or abrasive surface.
Full definition
Using a
hand electric sander might come in handy if you have several layers of paint that you want to expose.
Use a hand -
held electric sander to resurface the wood and remove any varnish, or simply to refresh previously oiled worktops.
The kids are off from school for winter break and the weather has been amazing so I grabbed my
favorite electric sander and my full of energy kids and took to the backyard.
Using a
hand electric sander can take off A LOT of paint, which often times forces you to go back and repaint some of the areas.
A pneumatic sander is a lightweight alternative to
an electric sander since the motor isn't built into the handheld unit.
I used
an electric sander and did it in the house instead of our shop because it was 105 degrees outside when I started this project.
For the middle section use
the electric sander in a few sparse areas, making sure it is heavier along the bottom.
I simply used a saw (yes, a saw) to cut the lucite to appropriate length and then used
an electric sander to buff out the rough edges.
But I don't have
an electric sander, and with 18 cabinet doors... I don't think my arms are prepared for this.
After the wood filler and epoxy putty have had time to dry, use a sanding sponge (or
electric sander) to sand the drawers smooth.
After painting two quick coats and allowing the table to dry thoroughly I sanded back heavily with
my electric sander.
At the same time, the artist interacts with the materials gesturally in his hallmark intuitive process of gouging, tearing, and cutting, bleach - soaking, singeing, caulking, and finishing pieces with
an electric sander.
His graphite drawings on walls, paper, and found maps are created from a layering process where the representational image is built only to be destroyed by the gestural strokes of erasers,
electric sanders, diluents, and other corrosive materials.
Collage, paper, oil, acrylic, pencil and
electric sander, 50 x 50 inches.
Despite the clean precision of his forms, Held would begin his paintings with loose improvisation, then erase his re-workings with
an electric sander.
A4 paper, photocopiers,
electric sanders, desk fans, ladders, light shades, lamps, chairs, cardboard boxes, bulldog clips; John Wood and Paul Harrison use the props of everyday life in the creation of minimal, enigmatic tableaux.
Existing between abstraction and figuration are the Toby Ziegler's images of Old Master paintings that have gone through a process of digital manipulation, and the removal of the finished image with
the electric sander to reveal the metal beneath.
Progressing into erasure, the paint is subsequently removed using
an electric sander to reveal the metal beneath.
A4 paper, photocopiers,
electric sanders, desk fans, ladders, light shades, lamps, chairs, cardboard boxes, bulldog clips; John Wood and Paul Harrison use the props of everyday life in the creation...
After sanding it really well with
an electric sander, I bought Valspar spray paint with a chalk finish in a very light gray color.
I had to take the bottom drawer and sand the print off with
my electric sander to start all over.
Then sand the entire piece with
the electric sander.
Lord knows I learned the hard way about using
my electric sander inside my shop.
After the wood filler and epoxy putty have had time to dry, use a sanding sponge (or
electric sander) to sand the drawers smooth.
I am planning on roughing them up with
an electric sander and then priming and painting.
We even went out and bought the fancy,
electric sander.
Took out
the electric sander and did a quick sanding of just those areas with a fine 320 grit paper.
I borrowed my mom's
electric sander..
I am wanting to get
an electric sander to help me refinish my grandmother's antique swinging door for our pantry!
While prepping the tables I realized how pretty the wood on the table tops are, and it took every ounce of me to not attack them with
the electric sander.
The first thing I did was break out not one but two
electric sanders, one for the larger flat areas and one for the smaller spaces.
Give painted furniture a distressed finish Rub down a painted armoire or a chest of drawers with sand paper (or use
an electric sander) to give it that timeworn finish.
Sponge sanders found at your local hardware store can be a great tool for distressing I have found using a sponge sanders can give you the flexibility and control than
electric sanders.
I could have used
my electric sander and saved time but when I was finishing this piece I was at my store and just wanted to get it done.
We removed the doors to do this and used
an electric sander outside.
SO I decided to get
my electric sander out and try to remove the «farmers» part.
Sand the entire growth chart using
an electric sander.
The photo above shows where I sanded the tile (50 grit paper using
an electric sander) and 1/2 of the area I had started to repaint.
After I sanded down the words and edges with a sanding block, I got out
my electric sander and sanded places around the milk jug to give it a more aged, «beat up» look.
I used our Grayco Magnum X7 Paint Sprayer, which saved so much time, and then sanded it for distressing with
my electric sander.
Sand the top of the table with
an electric sander.
TIP: Since the panelling has a rough texture, prime it first, then lightly sand with
an electric sander before applying the finish colour.
Now, use
an electric sander to distress any other areas around the board you want to look old until you achieve that rustic, chippy look we all love!
HI Veronica, I use
an electric sander to disptress my signs.
Phrases with «electric sander»