Sentences with phrase «electricity load by»

-- Always wanting to contribute more, you allow consumers to offset a greater portion of their electricity load by using less space - constrained space such as the parking lot.
New York and New England can increase Demand Response and Active Load Management to cover about 5,770 megawatts of electricity load by 2030.
New England can increase Demand Response and Active Load Management to cover nearly 3,000 megawatts of electricity load by 2030.

Not exact matches

Load shifting — The battery can provide economic benefit to its owner and the grid by charging during low rate periods when demand for electricity is lower and discharging during more expensive rate periods when electricity demand is higher.
A statement from the Ministry signed by Kweku Sesah Johnson said: «The Ministry of Power wishes to inform the public that its load - shedding programme, in respect of electricity supply, has been brought to an end.»
The three - paragraph statement signed by Kweku Sersah - Johnson, Head of Public Affairs, for the Power Minister, said» the Ministry of Power wishes to inform the public that its load shedding programme in respect of electricity supply has been brought to an end».
By lessening the load of electricity costs, these funds can be allocated to more important and vital services such as classroom resources, teaching staff and other educational tools.
A significant amount of electricity is required by a spark ignition system, and as engine speeds and loads increase, the ignition system consumes proportionately more electricity, while simultaneously becoming less efficient.
Electricity generated by regenerative braking may be fed back into the traction power supply; either offset against other electrical demand on the network at that instant, used for head end power loads, or stored in lineside storage systems for later use.
This motor can be used either to assist the 2.4 - liter gasoline engine when accelerating from standing and with increased load demand, or to charge the battery by turning the car's braking and deceleration into electricity.
The draft promotes renewable energy by requiring retail electricity suppliers to meet a certain percentage of their load with electricity generated from renewable resources, like wind, biomass, solar, and geothermal... [They] begin at 6 % in 2012 and gradually rises to 25 % in 2025.
Over the past several years, the peak load (or the most electricity required at any point) has fallen by between 2 and 3 percent.
Wind - generated electricity can not, by its nature, replace or displace these «base load» or «peak load» generators.
Based on IEA modelling of electricity consumption profiles by end - use, this potential represents the sum of all loads than can be shifted for every hour of the year.
Small (< 5 MW) geothermal projects could provide consumers with the same distributed power flexibility provided by solar and wind production with the additional benefit of being a more reliable base load source of electricity.
In 2016, coal - fired and nuclear power each contributed a bit over a third of the electricity, followed by natural gas generation, which provided a little more than a quarter of the load.
Replacing firewood with solar thermal cookers, or even with electric hotplates fed by wind - generated electricity or with some other energy source, will lighten the load on forests.
Electricity demand: The rate at which energy is delivered to loads and scheduling points by generation, transmission, and distribution facilities.
(B) the use of demand response technologies, practices, and activities that allow dynamic control, load - shifting, and reduction of time - based electricity consumption by load - serving entities and electricity customers, including the wide - spread installation or use of --
The CPUC would be required to increase the percentage of electricity output delivered by clean resources by 5 % in 2020 and by 6 % «every third year thereafter until December 31, 2029, or until 40 % of demand during the peak load time period is supplied by clean peak resources,» the bill reads.
Climate change denial, A; B; C; D; E; F; G Contraction and convergence; equitable sharing of the atmosphere Corporate greed: an unjust distribution of income; Demand side management, or price - responsive - load, relating to electricity supply; Dying languages Embodied energy (and embodied CO2) Energy Energy units, definitions and conversions; Energy density; Energy return on investment (EROI); Ethics: a hugely important subject that is little understood by most; The Great Golden Age Land ownership, or land stewardship?
Surplus base load generation caused by renewable energy will add more costs for electricity ratepayers 25.
Two - thirds of coal - generated electricity will be replaced by renewables — primarily wind power — while natural gas generation will continue to provide firm base - load reliability.
If electricity was dynamically priced, price fluctuations would be arbitraged by those market participants who could shift their demand or supply at least cost; among other things, this would remove the need for expensive peak - load plants and make solar and wind energy much more practical.
Concern mounted as higher - than - predicted temperatures pushed actual electric load (the electricity that the system operator must supply, as shown by the red line on the chart below) closer to the forecast (blue line).
Heavily reliant on oil imports and with an annual energy deficit of 3,478 GWh as of 2009, electricity in Lebanon is for the most part generated by hydroelectric and thermal generation at present and in addition, there are power reliability issues «such as load shedding, technical losses, and the aging of power plants», which again the addition of dispatchable renewable energy facilities is intended to counteract.
A part of the problem of the pseudo-random variability of supply and demand could be overcome by introducing Supply Dependent Load, which is discussed in my Sustainable Electricity page and hydropower could also be used to balance generation and consumption (as is done very effectively with wind power in Denmark balanced by hydropower from Norway).
An approach being researched by the content delivery network provider helps reduce the grid - connected load during peak demand periods, when electricity is most expensive.
The idea is to take a load off the plane's engines by powering non-propulsion systems - basically everything that run on electricity in the plane, light the entertainment electronics avionics, lights, etc - with a fuel cell rather than with the engines.
The physical system, however, of electricity as the authors directly phrase it is one that operates at a much faster rate than any other market.Therefore in this physical power system the supply and demand = generation and load must be balanced second by second or else there is collapse.
A power outage affecting 11,000 customers in the Sydney suburbs of Burwood and Strathfield at around the time of peak electricity demand (around 4 pm) was not caused by load - shedding, but would have reduced power demand at a critical time.
The project transforms the aging Unit # 3 at Boundary Dam Power Station near Estevan, Saskatchewan into a reliable, long - term producer of 110 megawatts (MW) of base - load electricity and reduces greenhouse gas emissions by one million tonnes of CO2 each year.
Use our interior designer resume template for Word and the examples below to create an impeccable work history section.Interior Designer — ABC Designs — Boston, MA — 9/2013 to Current • Work within a team of six to design and decorate the interiors of commercial properties of varying industries and sizes, undertaking up to five projects at a time • Coordinate and oversee construction, deliveries, plumbing and electrical work, and installations • Exceed annual company profit targets by 10 percent with increased referrals from satisfied customers • Utilize computer - aided drafting, technical drawing, and other design software to successfully confer with clients and project partnersInterior Designer — Joann's Interior Design Company — Boston, MA — 7/2009 to 9/2013 • Provided quotes and secured contracts for residential interior design jobs ranging from modest to extravagant design themes and budgets • Regulated and stocked inventories of supplies, materials, and equipment to avoid project delays • Ensured that building codes, plumbing, electricity, load - bearing walls and other structural components were taken into consideration for every assignment • Supervised an average of six projects at a time and consulted with clients on a weekly basis to determine preferences in lighting, furniture, color arrangements, and other design factors
a b c d e f g h i j k l m n o p q r s t u v w x y z