Not exact matches
Successful baking means
eliminating as much potential for
error as possible, and that means making sure your
measurements are exact.
And by increasing the dynamic stiffness we can nearly
eliminate the effect of electrostatic forces between the sample and cantilever body, which are major sources of
error in today's PFM
measurements, as mentioned.»
If we are looking to detect very small trends then we really do need to isolate as many other factors as we can and
measurement error is one of the simplest things to
eliminate.
Cogley (1999) referred to the use of this density of
measurements to
eliminate all but
measurement error, as reductio ad absurdum.
We hoped to
eliminate the mechanical devices that required more personal attention (taking
measurements, changing charts, etc.) At one point the electronic instruments showed a step change that was not reflected by the mechanical recorders and the electronic equipment designer asserted that the mechanical devices must be in
error because they did not show the step change.
The practical question that I think this leads to is how do we develop confidence that we have found all of the material
measurement error and properly
eliminated it?