(If you find it difficult to reach your leg, wrap a strap behind the knee, hold one
end of the strap with each hand, and gently bring the knee toward you.)
Holding onto one
end of the strap in each hand, press your right heel towards the sky as you gradually straighten your right leg.
In step 2, as you swing the bottom arm behind your back, slide the forearm as high on the back torso as possible (Remember to keep the elbow close to your side), then grab the
bottom end of the strap.
If it isn't possible for you to hold your ankles directly, wrap a strap around the fronts of your ankles and hold the
free ends of the strap, keeping your arms fully extended.
5 Hot glue the buckled end of the decorative strap at the 3 - o'clock mark on the mirror; hot glue the cut -
off end of the strap at the 9 - o'clock mark.
To tighten again, just pull
the end of the strap.
the sholder holes where the straps are fed through are wide and easy to get the straps through for adjusting the height of them, you do nt have to strain to slide
the end of the strap through.
It is easy to recline the seat one - handed, but to push the seat into an upright position, you need to use both hands to pull
each end of the straps apart.
It is easy to recline the seat one - handed, but to push the seat into an upright position, you use both hands to pull one
end of the strap and push the seat forward.
Hold
the ends of the straps from the left and right side of the seat.
Handles are on
each end of the strap while the loop connects it to the anchor point.
Place a yoga strap around the arch of your left foot, holding
the ends of the strap in both hands.
Your right hand will hold
the end of the strap with the flat metal strip.
If you are right handed, use your left hand to hold
the end of the strap with the two rings.
Stretch your arms straight forward, parallel to the floor, while holding onto
the ends of a strap.
Firmly pull
each end of the strap forward so that you start to feel space in the back crease of your knees.
Attached to
the end of the strap is a dowel that acts as a wedge between the dumbbells (or any weight that you're lifting) and your hands.
Have your partner sit in front of you, a foot or so away, and grip and pull
the ends of the strap, while at the same time pressing his / her feet lightly against the fronts of your shoulders.
Hold your ankles with your hands or, if you can't reach your ankles, place a strap around the front of your ankles and hold
the ends of the strap.
An authentic purse will never have
the end of the straps folded over.
Then, wrap
the end of the strap around a D - ring to see where the other hole should go.
A double chain ankle strap, at
both endings of the strap you will find black...
Sew one
end of the strap to each end of the handbag pouch, just past the corners of the zippers.
Whereas previous Fitbit bands (and the new Charge) had post-and-hole closures that many users found difficult to close, the Charge HR features a traditional watch band buckle made of surgical stainless steel, with a locking free loop to secure
the end of the strap to the band.
Tucked underneath the watch band is an optical heart - rate monitor and at
the end of the straps is a strong wristwatch clasp that is easier to fasten than Fitbit's usual two - pronged approach.
To swap in a new band, take one
end of the strap and slide it in from the bottom - right of your Apple Watch's case.
You have to stabilize the watch body against your wrist, line up the two
ends of the strap (much easier said than done), and then mash two metal prongs on one end into two stubborn holes on the other end.
The Onetouch Watch comes with a heart rate monitor on the underside, an NFC antennae for instant pairing (with select Alcatel devices at launch but will include more in the future) and a USB charger built into
the end of the strap.
Although we appreciate how easy it is to swap out by using the sliding mechanism found at
the end of the strap to unlock it from the case, the material of the strap itself is difficult to say the least.
Built into
the end of the strap is a USB charger, which you reveal by peeling back a protective cover that's part of the band.
A clever touch is the watch's hidden USB jack that is revealed when you flip open
the end of the strap.
Both ends of the strap have slots that run almost all the way to the face, both for the metal buckle's center post and for ventilation.
The battery tech will need to be both flexible and thin to be used in the strap, but the patent suggests this battery will be on
both ends of the strap and allow Samsung to include two batteries, neither of which will need to be in the body of the watch.
With the standard straps,
the end of the strap has a pin mechanism that slots into one of the remaining holes to keep the strap from flapping about, while with the leather strap, there is a loop for the rest of the strap to tuck into.
The standard straps and sport straps are fastened with a buckle and a pin at
the end of the strap that is secured into one of the remaining holes, while the leather straps also have a buckle fastening but the strap goes through a loop like a standard watch strap for a smarter look.
The slots continue around on the buckle -
end of the strap and higher than is reasonable on both ends, both for aesthetic balance and enhanced ventilation.
10 Attach the other
end of the strap to the cut - out circle directly opposite on the back side of the sheet.