Sentences with phrase «end of the wire»

No spark at end of wire from coil to distributor?

While he looked for the other end of the wire harness, I asked to inspect it and realized it was a LED assembly and not just a bulb.

Twist the bottom end of the wire around the vertical wire.

In this way, they were able to create an electrical contact with the second end of the wire, close the circuit, and measure the current.

Then check first to see whether the voltage is present at the motor end of the wire.

You should be fine as long as you don't touch the bare ends of the wires or mix up the colors.

Add beads to the other end of the wire.

To firmly attach the S - hook to an object like a bell, slip one end of the wire through the object's opening and pinch it tightly in place with your pliers.

You may need to shorten the shrink tube to allow exposure of the stripped end of the wire on the main bundle for crimping.

Alert the bank on the receiving end of the wire transfer, too.

To generate coherent light, photons must be reflected at the top and bottom ends of the wire, thereby amplifying the light until it reaches the desired threshold for lasing.

If a horizontal crossbar is hung from the lower end of the wire, in the manner of a rod in a mobile, it can serve as a pointer for indicating the angle through which the wire has been twisted.

At $ 69.99, it's in the upper end of wired mouse pricing, but for that price you get unique features and top - end hardware.

To secure the ribbon, I just tucked the two ends of the wired burlap between the layers of the wreath in the back.

Use pliers to press ends of wire tightly next to dowel.

I grabbed the end of the burlap ribbon that I had just bunched up and placed it on the BACK side of the wreath form behind the top divider bar and poked the two ends of my wire through.

Bend the other end of wire around the pliers in the opposite direction to form an S shape.

«This is Clarence Darrow,» said the voice at the other end of the wire, «I suppose you have been reading the papers, so you know Bryan and his outfit are prosecuting that young fellow Scopes.

However, the ends of the wires were not as smooth as he would have liked, and he would have preferred an 18/10 stainless steel construction for added corrosion resistance.

Leave about 1.5 inches at the end of the wire.

If desired, dip the end of a wire whisk slightly in to the topping and pull up quickly to create a few spikes of topping.

I just used a spoon to place a large dollop and then dipped the end of my wire whisk into it and pulled it out to make a few spikes on the top.

Good connectors at either end of the wire will keep the sound crystal clear.

I'm getting dangerously close to the end of the wire here.

Insert the ends of the wire through the holes and twist to secure using needle nose pliers.

Earlier evidence for the quasiparticles was found in one - dimensional nanowires, in which a Majorana fermion sat motionless at each end of the wire, like a particle bound to a particular spot within a material.

In a quantum computing system, information could be simultaneously stored at both ends of the wire, providing a robustness against outside disruptions to the inherently fragile quantum states.

But if two Majorana fermions were sitting at either end of the wire, each in the form of a hybrid between an electron and its positively charged partner, an electron - free «hole», then that could produce such a blip.

As you finish, bend over a length of the wire to create a «hook» at each end of the wire to hold the circlet.

When you have finished adding felt squares thread the end of your wire through the loop to create a circle and tie off.

Begin by measuring the rough circumference of your head with the wire and create a «hook» on each end of the wire.

Use pliers to make small bends at the ends of each wire.

Simply cut 4 - 6 inches and secure around your napkin bending the ends of the wire around each other to hold it in place.

When all the ends of the wire are secured you'll end up with a really tall tube of chicken wire.

The truly cautious will look for a wiring connector under the dash to disconnect, but I don't know exactly where it would be or what it would look like (though one end of the wiring should be going up into the steering column).

Check the other end of the wires to make sure you did not loosen them.

First pull a spark plug wire off, stick a thin screwdriver in the end of the wire where the spark plug goes.

This is a pretty simple problem, the ends of the wires into the sidelight connector corrode and this stops the sidelight / s from working.

Where does the other end of the wire that is running across the top of the fan shroud go?

Clip one end of the wire to a pin at the back and carefully poke the opposite end of your tester into each of the overhead console wires to test for continuity.

The connector may plug into the sensor itself, or there may be «pigtail» wires leading from the sensor with the connector on the end of the wires.

You need to get three of the same color in a row to destroy them and they can't reach the end of the wire or it will be game over.

The movement of the pieces of paper at the end of a wire attracts a cat's attention and awakens their natural instinct to hunt.

This is about a three - foot long stiff wire with tightly rolled paper on either end of the wire.

Privately held and not exhibited since the 1940s, the sculpture is composed of red - painted metal and wire, with a small black flower dancing at the end of a wire «stem.»

Joshua's Instrucable gives the detailed step - by - step, but the short of it is first stripping the ends of your wires, and wrapping them around and soldering them to your solar cell:

You'll need to hardwire the other ends of the wires to AC power (the third wire isn't used if you don't have interconnected smoke alarms).

Wiring that is intended for a wet location may be reused provided the ends of the wire or cable have not been exposed to water, he said.