Take a look on your phone and see if there is
enough battery life left — it is recommended to plug in the charger if the power left is less than 50 % (else your handset might get turned off in the middle of the root operation — if that happens, the phone might also get bricked).
Finally, you will have to make sure that there is
enough battery life left on your Sprint Galaxy S3 — so check the battery status and if the power left is lower than 50 %, plug in the charger before installing Android 5.1 Lollipop update.
You can safely flash the ROM only if your phone has
enough battery life left; so before doing anything else, check the battery status and if the power left is lower than 50 %, take your time and plug in the charger.
Since this is a manual installation procedure, completing the same will take a while (a couple of minutes to be more precise), so your phone must have
enough battery life left — if it gets turned off you might end up in bricking your device.
Before proceeding to download and install the update, make sure that your smartphone has
enough battery life left (preferably at least 50 percent) and it's connected to a strong Wi - Fi or cellular data network so that the update process goes smoothly and without interruptions.
An update operation can be successfully completed only if your smartphone has
enough battery life left — otherwise your device can get switched off right in the middle of the installation process.
This will cause your Roomba to start playing a little song (assuming it has
enough battery life left to do so).
Not exact matches
Also, your device should have
enough battery life for staying «alive» while the Jelly Bean 4.1.2 OS is being applied; so if there is less than 60 % power
left charge your Note 2.
The group says that at least 70 percent of all computer
batteries that are thrown out have
enough life left to power an LED bulb for a year, based on four hours a day of use.
This
battery case has
enough juice to fully recharge your S6 or S6 Edge, with a decent amount of
battery life left for another top - off later in the day.
Battery life also leaves a lot to be desire as the 2,110 mAh battery isn't enough to make this phone last throughout a full day without carefully monitoring your
Battery life also
leaves a lot to be desire as the 2,110 mAh
battery isn't enough to make this phone last throughout a full day without carefully monitoring your
battery isn't
enough to make this phone last throughout a full day without carefully monitoring your usage.
Your smartphone should have
enough battery life remained — more than 60 % power
left — or else you should plug in the charger first.
Then, make sure that your smartphone has
enough battery life for staying «alive» during the update operation; therefore is there is less than 60 % power
left first charge the
battery.
On the other hand, the phone must have
enough battery life (minimum 60 % power
left) in order to stay «alive» during the update process so use the charger before going any further.
Also, your device should have
enough battery life for staying «alive» while the Jelly Bean 4.1.2 OS is being applied; so if there is less than 60 % power
left charge your Note 2.
Also make sure that your phone has
enough battery life for staying alive during the flashing operation; charge the
battery if you notice that there is less than 60 % power
left.
HTC U11
Life owners who are eligible for the update are advised to download the firmware over a Wi - Fi network to avoid potential extra bill charges or slow transfer rates and should ensure the smartphone has
enough battery charge
left to last through the entire process.
With it's bold, bright and beautiful display and fast performance, Samsung has created a very good first generation Android Wear smartwatch, but is its
battery life leaves enough?