In flat Australia we have to get creative with pumped storage locations and look
for existing holes left by mines and quarries.
Ajayan says that about one in a hundred tubes were filled with lead, but only one in a million tubes naturally have open ends, so the lead is not entering
through existing holes.
The included offset studs and flag nuts
utilize existing holes in the chassis to mount the jacking rails to the rocker panels.
The bottom line is that BMO is essentially coming out with some «me - too» ETFs that don't
fill existing holes in the Canadian ETF lineup.
Please notice each of these methods can only be done
with existing holes — it doesn't help to prevent new holes from being dug!
I just drilled a hole in the top of the barrel and pulled the wires up through the
convenient existing hole in the back.
Odd that they could have filled the cabinet pull holes and used 1 knob or just used a new pull the right size
for existing holes.
On the glaciers of Svalbard, he added extra cryoconite sediment to
existing holes to see what would happen.
Is there a way to somehow put bolts in
those existing holes, fix them in place, then drill a hole in the 2x4 and hold it with a nut?
Humanely trap and relocate ground rodents, or hire a professional to do it for you, and block the entrance to
existing holes.
Then to secure the handle side of the paddle, I hammered one nail into the wall through the paddle's
existing hole.
Easy to install in
existing holes, easy to replace if they get dirty or worn, and they add a fun «twist» to your space!
I even thought about changing the hardware on it at one point to give it a new look, but of course I couldn't find any hardware that would fit
the existing holes or that I was really jazzed about.
Ours were the same way (formerly 3 inch holes) and it took me awhile to figure out how to hide
the existing holes and what size to order.
If the floorboard is damaged and it's not possible to nail in
the existing holes, pull out the nails with pincers or a claw hammer, then lift the board up and have a look underneath for cables and pipes.
First, we removed all the doors and applied wood putty to
the existing holes for the knobs and handles.
I didn't use
the existing holes — I made new ones!
Also for your pictures, did you just line up
the existing holes from the previous pictures or are you using hanging strips?
And don't you love it when you find hardware you really like and it actually fits
the existing holes?
I then used
the existing holes that came in my corbels to screw those to the doors and upper shelf.
I added screws through
the existing holes in the lid into the tabletop.