Start with
the fabric wrong side up and gather one end of the fabric about 2 ″ from the end then wrap with an elastic band.
Step 2) Place one strip of floral
fabric wrong side up, fold in the two short ends by 1 cm and press.
Then you'll find the matching center point for the other side of the fabric, and wrestle all that fabric around to pin the other side of the zipper to the other
fabrics wrong side as well.
I have learned over the years its best to fold and store
fabrics wrong side out.
Not exact matches
The pattern is only printed on one
side of the
fabric, so it's possible to wrap it the
wrong way and this may complicate your wrapping.
If your
fabrics have a right and
wrong side, baste them
wrong side to
wrong side.
Making your own bias tape, knowing right
side from
wrong side of ribbing
fabric and so much more... and you end up with a great towel bib that doesn't need to go over the baby's head.
(If the
wrong sides of the
fabric are inside, slide the transfer paper inside the
fabric.
If the
wrong sides of the
fabric are outside, place the
fabric inside the transfer paper.)
Depending on your
fabric strength, you may want to use interfacing to line the
wrong side of your
fabrics.
(Diagram below shows a right and
wrong side for clarification, but double gauze
fabric is generally reversible.)
Fold the yoke closed so that the
wrong sides of the two pieces of the
fabric are together.
Flip the pattern over and pin it,
wrong side up, to a single thickness of the right
side of your backing
fabric.
Place
wrong sides of the
fabric together.
Making sure you have
wrong side of
fabric and tee shirt facing you, sew together.
Use another backing
fabric to finish the
wrong side of the stuffed quilting.
Place the backing
fabric, such as batiste, on the
wrong side of the wool
fabric, and the paper pattern on the right
side.
Pin the two pieces of
fabric together,
wrong sides facing each other and sew with a 1.2 cm (1/2 ″) seam allowance.
On the
wrong side of the
fabric, which I've marked with an «X», mark in the zipper gap (i.e. the length of seam we will leave open for the invisible zipper will be inserted).
I actually used the
wrong side of the
fabric to complement the lapel... but... the difference is barely discernible.
The lapels are unlined -LCB- the
wrong side of
fabric shows -RCB- and so I chose to continue the gingham bias tape -LCB- self made -RCB- along the exposed front edges.
Did you mean to sew RIGHT
sides together??? Seems like it would only work to sew
wrong sides togeteher IF the two
fabrics are the same on both
sides.
The other piece of Velcro goes on the back or
wrong side of the
fabric.
Insert the cuff into the stocking with the
wrong side of the cuff
fabric facing out and into the
fabric, so it's next to the
wrong side of the stocking, and inside it.
Like above, make sure you don't trace both parts so you have the toe and heel parts made both of the
wrong side of the
fabric.
Fuse the fleece to the
wrong side of the outside
fabric.
Iron the shiny
side of the freezer paper to the
wrong side of the
fabric.
Iron a piece of fusible webbing a little larger than your deer onto the
wrong side of your deer
fabric.
Note: For the double layer, cut out a strip of
fabric doubled in width and fold
wrong sides together.
I've found that the «
wrong»
side of the
fabric is often my favorite.
Thread unlooped ends through needle; at grid mark on right
side of
fabric, push needle through to
wrong side.
But that's only my opinion:) You might want to try pinning the
fabric on your chairs with the
wrong side out and that way you can follow the lines of the chair.
Then you'll fold your
fabric in half with the right
sides of the
fabric touching, and the
wrong side on top.
Iron on the adhesive or apply
fabric glue to the
wrong side of
fabric, then fold and press to create finished edges.
After both pieces are pressed individually, center the batting on the
wrong side of the backing
fabric.
Place a main
fabric half circle
wrong side up (right
side together with the zipper).
Iron the shiny
side of the freezer paper to the
wrong side of the
fabric.
Step 3) With
wrong side facing, pin the
fabric trim along the width of the curtain along the non-frayed edge, frayed edge facing towards the top of the curtain.
Fold the card in half, and with
wrong side up, trim the
fabric along the fold, being careful not to cut into the card (Figure 4).
Step 4:
Wrong sides facing, fold your
fabric in half, pin the paper pattern on top and draw around it.
Step 4) Lay the
fabric down
wrong side facing and fold at the point at which the pole for the head end of the bed will thread through.
Step 5:
Wrong sides facing, stitch the first pair of
fabric pieces all round bar the central edge taking a 2.5 cm seam.