That way we could use the pneumatic
finished nail gun to hang the actual boards.
In performing their tasks, finishing carpenters are proficient in the use of
finish nail guns, hand planes, and chop saw.
A finishing nail gun (and a good eye for lining up the nails in the 1 inch area) secures the shelf bottom to the sides of the individual shelves.
Not exact matches
Ideal for painting, stapling,
nail guns, and inflation, this air compressor delivers 110 PSI from a three gallon tank, making it a great companion to help you
finish your projects like a professional!
Finish nails in my
nail gun held everything in place.
I
nailed the outside trim sides (1 × 4's) to the sheet of plywood using 18 gauge, 1-1/4 inch
finish nails and my Bostitch
nail gun.
They were super simple to put up with our
nail gun, and because our baseboard and crown molding are flat, everything
finished out nice and neat.
Using our
nail gun, we attached one full - length board to the ceiling, and then cut a smaller one to
finish off that «row».
Step 6: Using a
nail gun or hammer and
finish nails, attach the chair rail trim pieces you cut to the width of your shelves to the front of the 1» x 12» shelves and 1» x 2» strips on the sides.
If the shelves are level, attach the shelves from the top using a
nail gun or a hammer and
finish nails into the 1» x 2» strips below.
Using a pneumatic
nail gun and 5/8 inch
finish nails, secure the panel in place.
We then measured our center line, dabbed some E6000 glue to the applique (wood glue works just as well) and hammered in three small
finish nails (we don't have our
nail gun here but hand tools work just fine!)