Sentences with phrase «fins on»

Here's a sneak peek at some of our favourites, plus some additional whale themed products you can get your fins on...

I actually found the fit for my ears more stable (and the in - canal seal stronger) without the fins on, but all ears are different.

Nail blighters are bipedal anthropomorphic reptilian or fish - like monsters with red spotted skin and purple fins on its back.

As for the Vent Mount, that uses the same magnetic charging pad but backed with four rubber fingers intended to grip the vent fins on your car's dashboard.

If enacted, New York — one of the largest markets for shark fins outside Asia and the largest port of entry for shark fins on the East Coast — would join seven states and all three Pacific U.S territories in passing similar laws to provide critical protection to sharks and preserve the health of the world's ocean ecosystems.

New York — one of the largest markets for shark fins outside Asia and the largest port of entry for shark fins on the East Coast — joins seven states and all three Pacific U.S. territories in passing similar laws to provide critical protection to sharks and preserve the health of the world's ocean ecosystems.

According to the article, «It is illegal for U.S. fishing boats to dock with shark fins on board unless they are attached to the carcass, but fins are imported to the U.S. from countries with less stringent protections.»

It is illegal for U.S. fishing boats to dock with shark fins on board unless they are attached to the carcass, but fins are imported to the U.S. from countries with less stringent protections.

Picture the cooling fins on an air - cooled engine, or the concrete balconies that stud near every Vancouver condo tower.

On 19 September 2012, the Fisheries Committee voted on a draft report, which sought to maintain the status quo by continuing to permit the removal of shark fins on board freezer vessels.

On 16th December 2010, the European Parliament adopted a Resolution on shark finning that called on the European Commission to deliver a proposal to prohibit the removal of shark fins on - board vessels.

Anyway, in this design, we did not have room or budget for fins on the heat sink or a fan, so the heat elimination would be more radiative than convective — just a flat plate.

In March 2011, HSI called on the European Commission to prohibit the removal of shark fins on board vessels without exception.

The European Parliament consequently adopted a Resolution urging the European Commission to swiftly deliver a proposal to prohibit the removal of shark fins on - board vessels without exception.

Unfortunately, a massive trade agreement currently under negotiation between the United States and 11 other Pacific Rim countries seems to leave shark fins on the chopping block.

TreeHugger has covered the plight of sharks being hunted to extinction just for their fins on a number of occasions.

And, you know, the fins on my arms.

The Tzitzi - Ya - Ku uses the fins on its head to blind everything in a cone in front of it.

They have blue fins on their tails and back in this game, as well as blue spots on their undersides and a slightly flatter body shape.

With the small repairs and new fins on it, the boards are ready to use and deliver to the grommet surfer in all around Indonesia.

Odysseys Surf School will fix the board, put fins on it, and deliver to the child who needs it most, anywhere in Indonesia.

Odysseys Surf School will just need to fix some small dings & the fin's plug and then put the fins on it.

During the pool sessions you will gradually work your way through skills of varying difficulty, from swimming with fins on to perfect buoyancy underwater.

Something you can do to reduce the risk of injury is to put a set of soft fins on your surfboard.

If you were diving in Bali at Nusa Penida, usually at Crystal Bay, you might see this large almost flat, awkward looking creature appearing just like a large head equipped with long sweeping fins on top and underneath.

(Even the fins on this design are soft to a certain degree.)

Then it's masks on, fins on and into the water for your guided snorkel safari!

The car will be available in the exclusive paint finish Graphite Grey Magno, with black chrome highlights applied to the side skirt trim, front splitter, trim strips in the air inlets of the Panamericana grille, fins on the side air outlets in the front fenders, the modling on the rear diffuser and exhaust tailpipe trims.

To our eyes, the Golf GTI looks more aggressive than the R thanks to more unique wheels and the black fins on the lower front grill.

The AMG Exterior Carbon Fiber package highlights, once again, the motorsport heritage, bringing high - grade carbon fiber for the front splitter, side fins on the air outlets in the front fenders, exterior mirror housings, side skirt inserts (for the GT C only) and rear diffuser.

Using an angle of the lower section, the airflow underneath the body is improved while downforce is increased and the front radiator gets more air directed onto them, with the use of vertical fins on the side cool air is directed into the wheel wells better for better disk brake cooling.

Take a close look and you will notice the air vents on the side are much larger and the lower fins on the corners are more like the ones seen on the Murciélago Super Veloce, have them painted in matte black and they turn the Gallardo into a very aggressive looking Bull, ready to stampede over anything in its path.

From the outside, «Grand Edition» exterior badges, unique black rings on LED Intelligent light system and chrome fins on the bonnet are few things that differentiate the Grand Edition cars from the regular ones.

These accents, along with the grille surround, mirror caps, and the fins on the fender breathers are all finished in Cerium Grey Metallic.

You'll even find aero stabilizing fins on the tip of the doorframe molding and the rear lamps.

The car's exterior paint is combined with a high - gloss black finish in the radiator grille, the exterior mirrors and the fins on the hood.

The wing - like cross-fin and the star recessed into the radiator grille are finished in high - gloss black to match the exterior mirrors and the fins on the hood.

To really make a difference in the looks department there is new lower lip installed underneath the original front bumper, the clear carbon fiber unit from SR Auto Group shows small upward fins on the side for increased stability... according to ADV. 1 this is only the start, so I guess we'll be seeing some more aerodynamic parts being added to this already very nice looking Lamborghini.

The vehicle gets chrome accents on the fins on the bonnet giving it a different look.

The special edition SUV comes with «Grand Edition» badging on the exterior, chrome fins on the bonnet and blacked out rings on the full LED headlamps.

1956 was the last year for the knobby, P - 38 inspired tail fins on the rear of most Cadillacs, including the $ 4,587 Sixty Special.

Six months later DMC astonishes the tuning world again... with their third version on the Huracan, called the DMC Stage 3, which adds a Formula One look to the already impressive Lamborghini Huracan by installing a pair of vertical fins on either side of the front bumper.

Design elements that help control and direct the airflow include small but critical aero stabilizing fins on the front pillars, just forward of the door mirrors.

Let's start at the front, the entire original front bumper is replaced with an LB Works unit, that's the easy part, you also add a more pronounced, far forward and very low additional fin underneath this bumper, together with two vertical fins on both air intakes.

This time we did notice a different engine cover on these shots... the louvres returned, we've seen these on photos before but a different cover was shown on other test cars that featured a glass center with fins on the sides, however a recent article by «Only The Best» in which they state they actually saw the production car already, mentions a «Miura» style engine cover too.

Below this rear wing DMC removes the entire rear section of the original Aventador and replaces it with their own clear carbon fiber unit, complete with triangular styled air vents in the center and a multitude of vertical fins on the lower diffuser... I'm sure the DMC Aventador E-GT will drive at high speed like she's on rails.

The new front and rear design on the Aventador LP720 - 4 50 ° Anniversary isn't looks only, in fact the entire front splitter has been enlarged and extended to offer better handling at high speeds, the small upright fins on the sides do increase stability at speed too while drag characteristics haven't been impacted... actually this new design results in a 50 % increase of the aerodynamic efficiency over the standard Aventador LP700 - 4.

The Evo even has fins on the trailing edge of the underbody.

New «airblade» fins on each side of the lower front fascia are used to guide air to the intercoolers for cooling and Bi-Xenon headlights are standard on all models except the Turbo, which gets LED headlights.

Styling features include the flaps in the side air intakes, the trim on the diffuser and the fins on the roof spoiler.