Place a tight -
fitting lid on the pot and let it sit for 2 minutes.
Stir to combine and place a tight
fitting lid on the pan.
Put a tight -
fitting lid on.
Hi Shirley, a couple thoughts... did you have a tight -
fitting lid on it?
Add in the cleaned and de-veined shrimp, put the tight -
fitting lid on (no leaks!)
Not exact matches
Put in a jar with a tight -
fitting lid and store in refrigerator or in the freezer, if you intend to hold
on to it for a while.
The spinach: Wash and rinse a big pile of spinach, 6 - 8 cups or more — it cooks way down / In a large pan let a clove of finely chopped garlic sizzle in a couple of tablespoons of olive oil before adding all or most of the still - wet spinach to the pan / It will have a sizzling hissy
fit for a moment / Pop
on the
lid for a few seconds, turn spinach with tongs,
lid back
on / Add remaining spinach when there's room in the pan / Let it all steam with the
lid on for 3 or 4 minutes / When the spinach is wilted and tender remove from heat, salt lightly and set aside.
If anyone is curious, you can absolutely take leftovers for lunch — I just sprayed a shallow Tupperware that
fits them comfortably with nonstick spray, made sure the rolls didn't touch each other, and put some damp paper towels right
on top of them before I shut the
lid.
Cut small squares of craft paper that
fit on the
lid and hand - write Lavender Coconut Scrub.
A few days later, a
fit of «oh - my - goodness - where - are - those - custard - apples» was followed by «who - put - the -
lid - tightly -
on - the - box - argh - stop - cleaning - up - my - cooking - stuff» when I opened the tightly -
lidded box to find four enormous perfect ones, sitting in a box full of condensation.
I don't think I could use the big boys and be able to close the
lid on my grill and since I'll be attempting multiple recipes the smaller variety
fit the bill perfectly.
Using a clay pampered chef round pot with a glass
lid that
fit nicely
on top.
I pour the base into a glass bowl that will
fit into my crockpot and place the
lid on the crockpot (not the bowl).
Gently place peppers in a clean, sterilized jar with a tight -
fitting lid, layering them with the carrots and garlic, being careful not to press down
on the peppers.
Cover as best you can (my
lid barely
fit on top), and roast in the oven for 6 about hours or until cooked through.
Cover (if you don't have a
lid that
fits, use a sheet of foil) and cook, stirring occasionally, until clams have opened; this could take from 5 — 10 minutes depending
on size of clams and the heat level.
Place a clean kitchen towel over pot, cover with a tight -
fitting lid, and secure the loose edges of the towel
on top of
lid.
Like one bite here because that container is just a little too full, and just onnne more bite
on the way to the fridge to make sure the
lid will
fit... and the only way I can stop is by reminding myself I want to actually have leftovers to enjoy the next day.
Like one bite here because that container is just a little too full, and just onnne more bite
on the way to the fridge to make sure the
lid will
fit, and then pop the corner
on the container for just one more little taste once it's actually in the fridge, and then I better have a few more bites to even out all the containers because we have to be fair...
The design is flimsy, and the
lid has to be angled just right to
fit on the base.
It can be used even when
on journeys because the manufacturer's
fitted it with a snap -
on travel
lid which makes the first years take spill proof straw cup leak - proof.
For this, I just used a plastic film canister, you need the ones where the
lid fits neatly
on the inside not the outside.
Includes pan, strainer, pot,
lid (
fits on both pot and pan),...
The
lid is tight -
fitting, so I had a few problems trying to put it
on the first few times I used the machine.
Is there ANY ERF car seat with a prop leg that will
fit this car (either by reaching the bottom of the compartment or by sitting
on the
lid of the compartment, provided we have filled it)?
You might have to cut each piece in half again to make sure all pieces
fit with the
lid on the pot.
In the early years, provide lots of baskets or
lidded boxes sized to
fit neatly side - by - side
on the lower shelves.
Lid fits on top with a 1 - oz.
The BEST part though is that the
lid fits on to virtually any 8 ounce canning jar!!!
Skills developed: Familiarity with colors What you'll need: A clear plastic bottle with a tightly
fitting screw -
on lid, food coloring, vegetable oil, water, an Alka - Seltzer tablet
Put a
lid on the roasting pan, or some foil, and bake the whole thing (if you can
fit it) in the oven for three hours at 400 degrees.
If you don't have an oven, you can also make this
on the stove - top, by using a tight -
fitting lid, and keeping the heat low so it doesn't burn.
The narrow, 2.75» diameter glass cylinder
fits perfectly in most cup holders; the screw -
on lid keeps your tea securely in the bottle for carrying or transporting in a bag; the stainless steel micro-mesh infuser locks into place inside the bottle; securing the tea inside the infuser while drinking your tea.
Place a saucepan large enough to
fit the chicken in one layer
on medium high heat (you will also need a
lid for the saucepan)
Here is my recipe for Astragalus Bone Broth: Place chicken or other bones in a pot or crockpot Cover the bones with water Add about 2 tablespoons of raw apple cider vinegar for every 8 cups of water Add 1 ounce of dried astragalus root for every 8 cups of water or so Cover with a tight
fitting lid Simmer very low
on the stove or cook
on low in the crockpot for 12 - 48 hours Strain the broth and enjoy
The Tervis Straw
Lid fits snugly on your Tervis tumbler and this Tervis lid can accommodate a straw (sold separatel
Lid fits snugly
on your Tervis tumbler and this Tervis
lid can accommodate a straw (sold separatel
lid can accommodate a straw (sold separately).
I applied Take a Break
on my
lid, Centerfold in my inner crease, and Slim
Fit in my outer crease and
on my lower lash line (lightly).
It has a removable
lid that
fits perfectly
on top of the basket.
The kit is made up of bumpers, fenders, sills, door panels and a new boot
lid, and the parts either bolt into the existing
fittings, or they're
fitted on top of standard parts.
Other standard -
fitted and exclusive exterior details include the lightweight hood with eye - catching power dome, the font side panels made from aluminum, the sculpted front apron with three large air intakes, the black double - bar kidney grille, the hallmark M exterior mirror casings, the rear apron with integrated diffuser, the exhaust system with four tailpipes, and the trunk
lid with
fitted Gurney
on the BMW M3 or the aerodynamically shaped lightweight tailgate with integrated spoiler of the BMW M4.
Weight - optimised and crash - optimised body structure; standard safety
fittings include front and side airbags, side curtain airbags, 3 - point automatic belts
on all seats, at front with belt tensioners and belt force limiters, twin ISOFIX children's seat attachments at rear and optionally also
on the front passenger seat, tyre pressure control and partially active engine compartment
lid for optimised pedestrian protection; optimised vehicle weight; excellent acoustic and vibrational comfort; favourable aerodynamic properties.
• Body structure weight - optimised and crash - optimised; standard safety features including front and side airbags, side curtain airbags, 3 - point automatic seat belts
on all seats, with belt tensioners and belt force limiters at front, ISOFIX children's seat mounting at rear, Run Flat Indicator and partially active engine compartment
lid to optimise pedestrian protection; vehicle weight lower than in predecessor models and competitors in the segment in virtually all variants of the new MINI despite extended range of
fittings; increased acoustic and vibrational comfort: optimised aerodynamic properties as appropriate to each specific model including active cooling air flaps, underbody trim panel and air ducting elements in the upper section of the C columns; best aerodynamic figures within the competitive environment: Cd value reduced to 0.28 (MINI Cooper, MINI Cooper D).
• Body structure weight - optimised and crash - optimised; standard safety features including front and side airbags, side curtain airbags, 3 - point automatic seat belts
on all seats, with belt tensioners and belt force limiters at front, ISOFIX children's seat mounting at rear, Run Flat Indicator and partially active engine compartment
lid to optimise pedestrian protection; vehicle weight lower than in predecessor models and competitors in the segment in virtually all variants of the new MINI despite extended range of
fittings; increased acoustic and vibrational comfort: optimised aerodynamic properties as appropriate to each specific model including active cooling air flaps, underbody trim panel and air ducting elements in the upper section of the C columns; best aerodynamic figures within the competitive environment: Cd value reduced to 0.28 or 0.31 (MINI Cooper S).
When the new Seville came out four years ago, the trunk
lid didn't
fit properly
on early models.
Elsewhere, an active rear spoiler,
fitted for the first time
on a MINI, is also integrated in the boot
lid.
More than 1,000 new robots in the new body shop enable precisely crafted features, such as the laser - brazed roof and trunk deck
lid joints and consistent
fits on every car.
It's a clever device that is easily removed and has a release
on the driver's side to open up like a reverse - facing
lid over the rear seats for stowage of items that won't
fit in the boot.
Calling it the 1M RS, Alpha - N Performance
fitted the little BMW sports coupe with a comprehensive aero kit that features a wide range of components, including a ventilated carbon hood, front fascia add -
on carbon lower spoilers, carbon roof, carbon luggage
lid spoiler, and a carbon rear fascia diffuser.
The plastic trim pieces were
fitted with glaringly inconsistent panel gaps in the dash and centre facia — particularly around the glovebox
lids (upper and lower), but also under the vents and steering column
on the driver's side.
To add to the exterior design of the M550i, an aerodynamic kit is
fitted, which features an M spoiler
on the trunk deck
lid, quad black chrome rectangular exhausts and a Cerium Grey finish
on the side mirrors, kidney grille frames and Air Breathers.