Sentences with phrase «flathead screwdriver»

A small flathead screwdriver did the trick.

You could try working a small, thin flathead screwdriver into the gap between the base and the cap (the metal part with the contacts) and see if you can break the corrosion.

The only tool needed to remove and change the wiper blades is a small flathead screwdriver or a plastic pry bar tool.

To change / wash these, you'll need to remove the entire armrest assemble from the booster, then use a flathead screwdriver to depress a tab on the underside of the armrest.

Most late model cars have metal retaining clips that can be pried open with a butte michael kors handbags r knife or flathead screwdriver; some cars ma michael kors handbags y require removing screws.

If you're concerned about them standing out against the tire, you can remove them carefully with a flathead screwdriver, scrub off the remaining adhesive, and replace them in exactly the same spot with exactly the same number of weights of the same weight per weight of a different color (i.e. black) or paint them.

But when I use a flathead screwdriver to slowly deflate the tire down to 60 psi, it starts to look saggy.

The only tool needed to access and replace light bulb is a small plastic pry bar tool or a flathead screwdriver.

If you use a flathead screwdriver, I recommend covering the blade with a thin micro fiber cloth to prevent from scratching the plastic surfaces.

The only tool needed to access and change the battery is a small flathead screwdriver or a plastic pry bar tool.

The tools needed to remove the door panel include a small plastic pry bar tool, a flathead screwdriver, a 10 mm socket and a 1/4» drive ratchet.

Carefully pry out the old battery from the socket with the flathead screwdriver or your fingernail.

Gently pry out the trim piece located behind the door opener handle with a flathead screwdriver.

Insert the blade of a small flathead screwdriver or the tip of a plastic pry bar tool into the notch on the inner edge of the access cover.

The only tool needed to access and replace the bulbs is a small flathead screwdriver or a plastic pry bar tool.

Gently pry out the pop rivet friction fastener at the front top corner of the plastic door panel with a pry bar tool or a flathead screwdriver.

The only tool you might need is to access the front turn signal light bulb on the passenger side is a small flathead screwdriver or a plastic pry bar tool to remove the wiper fluid filler tube.

Bring Supplies: Have Phillips and flathead screwdrivers and scissors (to cut rubber gaskets when using smaller clamp for rear light) on hand.

Two small screws hidden at the top of mounting plate can be turned with a flathead screwdriver to further secure the bell.

However, Rose said there was a YouTube videos that showed one secure model, the Kwikset Kevo, being opened with a flathead screwdriver.

I recommend using a flathead screwdriver instead of a pocket knife as demonstrated below.