Apply
some glue along the edge of the carton piece all over the outside, or wherever you wish to have some glitter, and sprinkle the glue with glitter.
Repeat
the glue along the edge and add the pieces together alternating blue and white until the last piece.
Squeeze a line of
glue along the edge and use the small paintbrush to spread the glue (see picture below).
I drew a small bead of wood
glue along the edges to be nailed and held it for a few seconds.
Not exact matches
Dip your finger in a small amount of water and trace it
along the
edges of your wrapper — this will act as
glue to hold everything together.
Starting at the center back of the picnic basket lid,
glue a piece of leather trim, embroidery thread, or ribbon to the
edge of the basket lid, just below the top
along the
glue line
Start with a painted hoop and then
glue the ruffle
along the back
edge.
Using a hot
glue gun, attach crayon by crayon
along the top
edge of the canvas.
Get your toddler to
glue / sticky tape the strips
along the straight
edge at the bottom of the jellyfish (see pictures).
After the
glue has dried, fold slightly
along the four
edges of S5, so that each attached slope angles slightly downward toward the center.
Continue to add the folded pumpkin shapes,
gluing along the center folded
edge.
Put
glue along one
edge of the burlap.
Since I wanted to finish the runner before my kids came home from school, I used fabric
glue to
glue decorative ribbon trim
along the long inside
edges of my runner and to add some decorative felt craft buttons to the center.
Lever the battery up and work the plastic opening tool down
along its
edge to release the
glue securing it to the frame.
Now for the lampshades I simply just hot
glued the trim right
along the
edge of the lamp shade.
Apply a thick line of hot
glue from the top of the container,
along the
edge of the opening, down to the bottom of the container.
Then Pookie laid the lumber out on the floor of our garage, using wood
glue along each rabbited
edge, and allowed it to thoroughly dry.
Then I applied wood
glue along each board
edge and connected the boards together using 2 1/2 ″ Kreg screws.
Add a vintage touch by
gluing flat tasselled fringes
along the
edges.