The phrase
"head screwdriver" refers to a tool used to tighten or loosen screws. It has a handle and a shaped tip that fits into the slot on the screw head.
Full definition
Just swap out the Phillips
head screwdriver in the Fieldmaster with a corkscrew, and you have the Fieldmaster!
Release the hinge clasp by pushing the securing metal clasp (painted white on my vehicle) with the flat
head screwdriver towards the rear of the car.
Faux pumpkins - enough for each house number (Purchased at JoAnn Fabric) Plastic house numbers in style of choice (purchased at Home Depot) Container of choice (purchased at Home Depot) Wooden Dowel Newspaper Spanish Moss Hot Glue Gun Knife Philips Head Screwdriver
Arm your little engineer with a few sizes of
Phillips head screwdrivers, and then allow her to dissect memory cards, motherboards, hard drives, circuit boards and cooling fans.
You could also try using
flat head screwdriver, just be careful to prevent scratching your dash or other components.
In addition to the pins and the beads, it is helpful to have needle - nose pliers and a small flat -
head screwdriver.
To wash the canopy, remove the metal and plastic frame that run the width of the fabric (you will need a Phillips
head screwdriver to remove).
The knife comes with a small blade, nail file, flat
head screwdriver, scissors, keyring, tweezers, and toothpick.
I took off the cover fabric with a flat -
head screwdriver and pliers.
Sometimes a good scrape with a flat
head screwdriver will do the trick, but so might some wire wool.
I removed the retaining clip from the back of the harness plug by prying it with a small flat
head screwdriver and cleaned out the plug first with carb cleaner and then with electrical contact cleaner, front and back.
I used a flat -
head screwdriver to pry one of the bolts slightly out, and then a pair of pliers to strip material off the head of the bolt until it was small enough to just slide the splash - guard off of the remaining stub.
Use a small flat -
headed screwdriver to slide between the two levers on the driver's door sill to manually unlock them.
The OEM door speaker can be removed with a 10 mm socket and a 1/4» drive ratchet or a Phillips
head screwdriver.
The speaker is held in place by three screws that can be removed with either a 10 mm socket and a 1/4» drive ratchet or a Phillips
head screwdriver.
How she set her highball on the tub's edge, digging out the old grout using a flat -
head screwdriver.
But if you're planning to do your own upgrades, all you need is a standard phillips
head screwdriver to remove the four screws on the bottom cover.
No problem, as long as you're familiar with a Phillips
head screwdriver.
All I needed was a Philips -
head screwdriver and a measuring tape, and the installation process took me no more than 20 minutes from start to finish.
If you aren't rerouting wiring to a new location (which could require a specialized drill if you're installing it on a brick facade or some other tough surface), all you really need is a Phillips -
head screwdriver, which SkyBell includes in the box.
To do this, you will need a Phillips -
head screwdriver.
For those who have never put up a shelf before you'll want to be sure that you don't mount directly onto drywall, so a level, a Phillips
head screwdriver, and a stud finder are all handy to have on hand.
After I used the included screws to attach the baseplate to a wall, I connected the appropriate wires to the terminals on the baseplate — you'll need a small flat -
head screwdriver.
The front - based hot - swap hard drive bays make installing a new drive dead simple, and while the 2.5 inch solid state drive bay is a bit more difficult to access, but it's still a five - minute job for anyone with a Philips -
head screwdriver.
All one needs to get inside the console is a Phillips -
head screwdriver, and things like the hard drive and video card can be easily upgraded.
Experience with: Air compressors, Face masks, Overhead cranes, Phillips
head screwdrivers, Power grinders, Power saws, Safety gloves, Safety goggles, Utility knives
To get though all those layers of paint, I carefully chipped it away with a thin flat
head screwdriver and removed it from the door.
I love that the lids on the Americana paint are screw - top, meaning I didn't have to hunt down my lid - topper - popper, or a flat
head screwdriver to open my paint.
Simple to assemble, with just a Phillips
head screwdriver.
Simple to assemble, requiring only a Phillips
head screwdriver.
Simple, hassle - free assembly with just a Phillips
head screwdriver.
I was able to pry up mine with a flat
head screwdriver and a hammer, but yours may be screwed or glued down.
Phrases with «head screwdriver»