Perhaps when you were a child you poked a few
holes in the lid of a mayonnaise jar and collected insects for observation.
Add one cup of baking soda into the Mason jar, drip in 7 - 8 drops of oil, poke small
holes in the lid of the Mason jar, then hide it somewhere underneath a seat in your car.
Unwrap the burger, squirt ketchup on the fries, stick the plastic straw through
the hole in the lid of your drink.
Not exact matches
I received this product
in great condition and on time.The problem came about four days later.I opened the
lid to find that there was stowaways
in there.Little bugs that were eating
holes on the inside
of the bowl.Outside
of that the finish was nice.A bit dissapionted
in the fact that there is bugs
in the product.
In half the cookies (the «lids»), cut a small circular hole in the middle (I used the lid of an olive oil bottle to do thi
In half the cookies (the «
lids»), cut a small circular
hole in the middle (I used the lid of an olive oil bottle to do thi
in the middle (I used the
lid of an olive oil bottle to do this)
This mash is placed
in Kentucky white oak barrels with salt - sealed wooden
lids that have tiny
holes which allow the gases
of the peppers to escape during fermentation.
I poke a very small
hole in the
lid (you can see it
in the exact center
of the above
lid) to allow the gas from the yeast to escape.
While blending, slowly add butter through
hole in top
of blender
lid; blend until combined and sauce thickens, about one minute.
Once cool, cut a small whole
in the middle
of each cupcake, reserving the
lid / top
of the
hole that was cut out.
Tip
of the day here — when working with hot liquids, do not fill the blender more than halfway, and partially cover the
hole in the
lid with a dishtowel to allow steam to escape.
Show your toddler how to unscrew the top, remove the spaghetti, replace the
lid and then place the spaghetti back
in the bottle through the
holes in the
lid.NOTE Once my one child tried to eat a piece
of dry spaghetti and it got stuck
in her throat.
Appropriate for: 7 to 18 months Skills developed: Fine motor, sense
of cause and effect What you'll need: A small, empty, clean plastic food container (like a tub that held cottage cheese or yogurt) with a
lid; something sharp to make
holes in the container's
lid
Stream the oil
of choice into the food processor via the small
holes in the
lid all the while pulsing the food processor to emulsify the oil with the other ingredients.
Starting at a lower speed, drizzle the olive oil through the
hole in the top
of the blender
lid.
Sam wrote: «For those
of you who have a frequent / infrequent leak
in your trunk, the most likely source are 2
holes a little larger than a quarter
in diameter, that are
in the top portion
of the trunk between the rear - window and the trunk
lid.
You'll need to modify the
lids for proper ventilation by cutting a large
hole in the center
of the
lid and replacing it with hardware cloth.
Simply measure and cut a
hole in the
lid (nine inches
in diameter should be plenty), apply the shelf liner to the top
of the
lid as an anti-tracking mat, and fill with litter.
Although you should make sure that this is a wire mesh
lid, rather than a solid
lid with air
holes which will result
in ventilation problems and a build up
of condensation.
Round Things with a
Hole in the Middle Most
of the Time, 1990 --(ongoing) Glass jar with plastic
lid, found objects Dimensions variable Photographs by Adam Reich, courtesy
of The Pace Gallery
Millions
of these
holes, generally ranging from the width
of a pencil to the width
of a garbage can
lid, pockmark ice sheets
in a Swiss cheese - like pattern around the world.
I've used a large pickle container (the Warehouse size) on counter with a few red wrigglers thrown
in on top
of leaves or shredded mail and then just put scraps
in and cover with a
lid pierced with some air
holes... if fruit flies are a problem, a cloth or paper towel with rubber band or screw you nail pieced
lid right over.
We began noticing a pattern: Regardless
of the receptacle's label, recycling bins with little
holes in the
lids contained recyclables and almost nothing else, while those that lacked those
holes were basically used as trash cans.
Platters, pitchers...... sweet little creamers and gravy boats...... and this very unique brush box... At least, it's the shape
of a brush box, but I've never seen ones with
holes in the
lid.
Then, take the end
of the string without the knot and push it through the
hole in the
lid.