Since I knew nothing about construction, I was unaware that the 2 × 4 framing studs for the ceiling needed to be spaced to match the 48 -
inch sheets of plywood.
Not exact matches
The cargo bed is five feet four
inches long and five feet wide; a four - foot - wide
sheet of plywood will fit between the wheel arches.
Of equal practicality is a pickup bed 5.4 inches wider and four inches longer that Honda says makes the Ridgeline the only mid-size pickup with a flat 48 - inch load surface between the wheel wells, to accommodate full sheets of drywall or plywoo
Of equal practicality is a pickup bed 5.4
inches wider and four
inches longer that Honda says makes the Ridgeline the only mid-size pickup with a flat 48 -
inch load surface between the wheel wells, to accommodate full
sheets of drywall or plywoo
of drywall or
plywood.
As shown in the concept, Durango now has the capability to carry 48 -
inch wide
sheets of plywood between the wheel wells.
It's wide, too: Lash a 4 × 8
sheet of plywood sideways to the roof rack and the ends would stick out just 2
inches past the mirrors.
We'd constructed the roof from a 3/8 -
inch - thick
sheet of mahogany
plywood, reinforced with a layer
of six - ounce fiberglass.
Preparing his signature surface involves bolting a standard four - foot - square
sheet of plywood to wooden stretchers, onto which he glues 12 -
inch - square vinyl floor tiles and applies butyl rubber (commonly used in roofing) to the surface.
Once the mix is soft enough, it's placed in a hydraulic press where it is flattened into panels approximately 8 feet long, 4 feet wide and 1
inch thick — about the size
of a standard
sheet of plywood.
The rustic mirror looks great against the planked wall, which can be made inexpensively by cutting 4 - x 8 - foot
sheets of plywood into 6 -
inch - wide strips.
I nailed the outside trim sides (1 × 4's) to the
sheet of plywood using 18 gauge, 1-1/4
inch finish nails and my Bostitch nail gun.
Next, I purchased 4
sheets of 1/4 ″
plywood at Home Depot for $ 13.97 each and had them cut it into 6
inch wide planks.
Using a portion
of a
sheet of 1/4
inch plywood this project costs less than $ 15.
We didn't do one, but we just bought
sheets of plywood and had them cut into five
inch strips to use as paneling for our walls.
I had them rip the
sheet of plywood into four 11 7/8
inch wide pieces.