The contractor, Silvia and Silvia of Osterville, built the double stud framing which allows a continuous
layer of foam insulation (uninterrupted by studs).
Not exact matches
• The steel front -
of - dash panel is sandwiched between two damping mats • Nylon baffles are used in various hollow portions
of the body structure and filled with sound - absorbing
foam that expands when the body enters the paint oven • The headliner comprises five
layers of thermal fiber acoustic material, including a premium woven fabric on the visible outer
layer • Patches
of sound - damping material are applied strategically throughout the body structure and melt into place when the body passes through the paint oven, allowing the patches to follow the contours
of the sheet metal below • Sound
insulation material between rear - body structural components that is made from recycled denim • Triple - sealed doors that feature fiberglass «blankets» serve as water, airflow and noise barriers.
They recommend putting down a
layer of spray
foam first, which will air - seal the attic, then blowing in cheaper loose - fill
insulation on top.
SSIC panels most generally consist
of two
layers of oriented strand board (OSB) as structural skins separated by
foam insulation.
Retrofitting a wood - framed enclosure with thick
layers of foam plastic
insulation board is a proven high performance retrofit technique.
Photograph 11: Roof to Wall Air Seal — Note the connection
of the new roof deck membrane overlapping the trimmed back original gable overhang and catching the «white» housewrap water control
layer and air control
layer behind the wall exterior
insulation (the «blue»
layer of foam).
Roof Assembly: R - 60 (nominal) vented attic: existing slate shingles, underlayment, and board sheathing; in knee wall and at sloped ceilings, 1»
layer of polyisocyanurate rigid
insulation between rafters, held away at least 1» from board sheathing, covered with closed - cell spray
foam; attic above flat ceiling has deep
layer of cellulose.
The types
of building products impacted by the REACH phase - out
of MDA include high performance coatings, flooring adhesives, carpet backings, sprayed polyurethane
foam insulation, composite wood, and resilient flooring compositions that contain polyurethane wear
layers.