At the back of the Sonos One you'll find the pairing button along with an Ethernet port, but
no mounting screw hole like the Play: 1.
On the top of the Play: 1 there is a physical Play / Pause button, volume rocker and a status LED light, while the back has a stand
mounting screw hole.
Not exact matches
If you're drilling into wood studs, the way to go about
mounting it is simply using 1 / 4 - inch lag
screws (to fit into 3 / 8 - inch
mounting holes).
Three
screw holes for wall
mounting; two...
Hard -
mount screws only included for the 3
hole pattern, pre-mounted with the 20 ° angle adapter.
And the wall plate it comes with, while it has two
holes for
screws, has them in a nonstandard configuration on the left and right sides, not on the top and bottom like you'd want in order to
mount it to a receptacle in place of a switch.
Indeed, it's the same
mounting system — a metal plate
screws into the same
holes the old deadbolt lever used, and then the August lock clips onto that with a pair of latching arms — as the first and second generation models.
If the exterior of your house is brick or masonry, you'll need to use the included drill bit to drill
holes where you made marks, and then insert in the two yellow wall anchors before
screwing on the
mounting plate.
The camera sits magnetically in a circular plastic cradle, which itself clings magnetically to a round metal
mounting plate with two
screw holes.
This final type of cooler contains a backplate and requires you to
screw the cooler on using four
mounting holes on the motherboard.
On the top can be found a speaker grill, which comes in handy for two - way audio and for sounding an alarm, while on the bottom you'll find a
screw -
hole for
mounting the camera to a tripod or another type of bass, if you so choose.
Around the back of the Play: 1, you'll find a
screw hole for
mounting this compact speaker to a wall and an Ethernet socket if you want to hardwire the Play: 1 to your network rather than connect it wirelessly.
Thread the light fixture wires through the center
hole and
screw on the
mounting nuts to the
mounting screws.
Step Two: Mark the
screw holes on the wall or unit you will be
mounting the light too.
The 2 side
holes are the
screw holes where the light will be
mounted to the metal
mount and wall unit (bookcase).