In an article published in Nature Communications Uppsala physicists make a big step towards this goal — they propose and demonstrate
a new measurement method capable to detect magnetism from areas as small as 0.5 nm2.
Not exact matches
Weingarten cautions against equating R&D spending too closely with innovation, noting that many oil and gas companies fare poorly under such
measurements because of Statistics Canada's criteria for research spending, but still frequently develop
new methods and ideas.
This ultimate
method for unraveling ensemble averages leads to the observation of
new effects and to direct
measurements of stochastic fluctuations.
Unlike a GPS
method proposed last year, which detects seismic waves transmitted through the Earth's crust to distant receivers, the
new ground - based system takes real - time
measurements of vertical ground motion — the type of fault movement more likely to produce tsunamis (Journal of Geophysical Research, DOI: 10.1029 / 2006JB004640).
Once observations of the moment of inertia will be possible through the
measurement of binary pulsars, the
new method will allow us to measure the stellar radius with a precision of 10 % or less.
The
new NIST crack - detection
method relies on acoustic
measurements at frequencies much higher than humans can hear.
The deployed
method will also open a
new window for future
measurements of particle formation in other chemical systems.
The
new experimental
method, proposed by Prof. Silvia Leoni (UniMi), combined with the computationally extremely sophisticated Monte Carlo shell model developed by the Tokyo University theorists, enabled the design of appropriate, accurate
measurements.
This
new method shows that it is not a factor of
measurement error and that the Earth has in fact warmed, said Compo.
The STED - RICS
method opens up
new measurement applications in life sciences.
The
new approach also seeks to transform firearm identification from a subjective
method that depends on an examiner's experience and judgement to one that is based on objective
measurements.
«Air quality
measurements:
New manufacturing
method for nano gas sensors opens doors.»
With the
new method, a much smaller number of
measurements could do the same job, and substantially larger systems, previously inaccessible, could be studied.
Based on the comprehensive
measurement data and
new visualisation
methods for these data, the researchers can thus gain a grasp of phase evolution in complex alloys within a much shorter space of time than with traditional
methods.
They used a
new analytical
method perfected in collaboration with Joe McConnell at the Desert Research Institute in Reno, Nevada, to make extremely detailed
measurements of the air trapped in the ice.
In a
new study published in the journal Physical Review Letters, he and his colleagues present a
method for doing just this by studying the phenomenon through three different independent
measurements.
Hayashi and Niwa expect the non-invasive force
measurement method to be a strong,
new tool in understanding the physical mechanism of neuronal diseases caused by deficits in axonal transport.
«
New method enables high - resolution
measurements of magnetism.»
Volcanologists are beginning to use satellite
measurements and mathematical
methods to forecast eruptions and to better understand how volcanoes work, shows a
new article in Frontiers in Earth Science.
It was a time when investigating the natural world, the
methods shifted to empirical
methods, to
measurement and mathematical analysis, so engineering became part of learned culture in a sense, and that broad context is important for the development of
new methodologies.»
Bato and her collaborators are among the first to test whether data assimilation, a
method used to incorporate
new measurements with a dynamical model, can also be applied in volcano studies to make sense of such satellite data.
Development of
new instruments and
methods for
measurement of properties of atmospheric aerosols and cloud - aerosol properties
Since it is still
new, it ranks a little lower than the older
measurement methods.
Since the development of
new nanoscale
measurement methods is also a high priority, we are developing multi-probe scanning probe microscopes and other cutting - edge instruments.
The related research and applications are similarly diverse, fluctuating from extensions of conventional device physics to totally
new methods based upon molecular self - assembly, from emerging
new materials with
measurements on the Nano scale to straight regulator of matter on the atomic scale.
And some of the
new imaging techniques we're developing will allow us to achieve more precise and informative
measurements in patients than many of the standard
methods.
Dr. Grate has a distinguished career in chemically selective materials, chemical microsensors and analytical fluidics that integrates aspects of the chemical sciences, material sciences and
measurement sciences into
new microanalytical principles,
methods, and systems.
The
measurement community cautioned that the field would require
new models for and
methods of determining the technical merit of
new assessments (Linn, Baker, & Dunbar, 1991; Moss, 1994), many of which were not yet in place.
While traditional
methods of measuring reading rely on quizzes and end - of - year results, myON incorporates
new technologies that enable seamless
measurement to monitor student engagement and reading growth as they occur, all year long!
* Data determined in the NEDC (
New European Driving Cycle) in accordance with the Euro 6 (715 / 2007 / EC, 195 / 2013 / EC and ECE - R 101.01)
measurement method.
Data determined for standard specification and in the NEDC (
New European Driving Cycle) in accordance with the Euro 5 and Euro 6 (715 / 2007 / EC and 692 / 2008 / EC)
measurement method.
Then in 2003 the launch of two
new satellites, ICESat and GRACE, led to vast improvements in one of the
methods for mass balance determination, volume change, and introduced the ability to conduct gravimetric
measurements of ice sheet mass over time.
However, a
new study by Garcia - Eidell et al. shows that satellite - based
methods produce reasonably accurate
measurements of Arctic sea surface salinity from season to season and year to year.
Current research efforts in the Heterogeneous Catalysis project involve the design and study of
new oxygen - and hydrogen - evolving materials and development of novel surface characterization
methods for in situ
measurements.
The
new method reduces the bias between the TOMS UV estimations and ground - based UV
measurements for snow periods.
The fact that
measurements recorded by all these different
new methods ranged from 500ppm to 100ppm means that they were all wrong.
The main improvements with respect to V2 version flux products (Bentamy et al, 2008) are related to the improvements of the specific air humidity estimation from radiometer
measurements, to the assessment of the surface winds retrieved from QuikSCAT scatterometers, and to the use of the
new objective
method allowing the calculation of flux analyses over the global oceans.
Scientists at the University of Bremen, who use a slightly different
method to calculate sea ice extent from AMSR - E
measurements, declared that 2011 surpassed 2007, setting a
new record low.
The
new methods result in improved agreement between
measurements made by different satellites at the same time.
«
new method finds a global - mean land diurnal cycle that peaks later in the afternoon, leading to improved agreement between
measurements made by co-orbiting satellites.
Directed and improved search marketing processes and results incorporating industry best practices, third party software tools (Coremetrics, HitWise, Google Analytics, Google AdWords Editor, Channel Advisor, etc) and
new methods for delivery and
measurement
Environmental Engineer — Duties & Responsibilities Trained environmental engineer with experience in industrial and academic settings Oversee development and feasibility study of a
new low level chlorine detection
method by nanotechnology Direct identification and quantification of sulfate - reducing bacteria (SRB) and sulfur - oxidizing bacteria (SOB) by Real Time Polymerase Chain Reaction (RT - PCR) Lead research for «Control of distribution system water quality in a changing water quality environment» funded by Tampa Bay Water Authority, Water Research Foundation Responsible for analyzing biological parameters and interpreting data from distribution system samples Manage QA / QC and sampling protocol for all biological project samples Compose and organize the entire biological sections for final project reports Develop and verify empirical models relating biofilm density and HPC
measurements to water quality Responsible for designing water, sewer, fire, and storm drainage systems for a 3 story building Composed an Operations & Maintenance Manual for drainage systems Drafted full - size CAD blue prints of drainage systems and other structures Proficient in water / waste water treatment, experimental design, and laboratory studies Provide research for a project studying the effects of ultra-filtration on oily waste water Create a full 40 MGD water treatment plant process and design for a fictional city in North China Oversee site and source water selection, water pump stations design, treatment plant planning and pipeline layout Drafted full - size CAD blue prints and composed an Operations & Maintenance Manual Experience with hydraulic modeling and waste water plant design Consistently recognized for excellence in team leadership, project management, and academic study
These
new systems overcome the faking, subjectivity, and reference bias problems that plague «first generation»
measurement methods.
And as the World Economic Forum so clearly establishes,
new and better
measurement and assessment
methods are essential to the advancement of this mission.
However, pediatric psychology researchers also need to make better use of
newer statistical
methods that allow for better testing of latent constructs, factor structure relations, and assessment of
measurement invariance across populations.
BOMA often is asked why we adopted the
new IPMS for Office Buildings when the BOMA Standard (Office Buildings: Standard
Methods of
Measurement - ANSI / BOMA Z65.1 — 2010) is the prevailing standard in the U.S. and many countries across the globe.
Because of our commitment to data quality, in 2011, REDX pioneered an innovative
new measurement of lead quality (known as Octane ™) as well as a
method of data quality analysis, and conducted an exhaustive study comparing its product against 22 of the largest national data providers.