Sentences with phrase «of evaporators»

Use various computer resources and programs such as SAP to order parts, and ALC control various functions of evaporators and air makeup units throughout the 700,000 ft2 production plant.

SiccaDania, established in 2014, is a provider of evaporators and dryers for food, dairy and starch applications globally.

Heat treatment is often an integral process step of an evaporator in order to achieve specific properties in the finished powder.

Then measure the temperature of the line itself near the service port after it comes out of the evaporator using your digital thermometer.

The purpose of superheat and subcool is to tell you about where in the system the freon is either changing from vapor to liquid (subcool) or from liquid to vapor (superheat), you want this change to occur in the center of the evaporator or condenser..

The cooling rate of the evaporator has not changed, it is still pulling in a fixed amount of heat.

Now, the temperature of the evaporator core rises proportionately as the temperature and flow of «hot» air across it.

The drain of the evaporator comes out of the firewall in the engine compartment and the drain can get clogged by debris...

Much of the available temperature differential is lost in the temperature drops of the evaporator and condenser heat exchangers.

Not exact matches

Stay fresh The T9000's triple cooling system uses two compressors, three evaporators and an array of sensors that Samsung says maintains commercial - grade humidity that will keep your food fresher for longer.

Finally, an inventive redesign of the icemaker evaporator.

«With the expertise gained through ACO, SiccaDania has now established an After - Market Division — a separate group focused on the rebuilding and optimization of existing dryers, evaporators and other food processing equipment,» Rasmussen said.

The sap is moved into an evaporator, where it snakes through a series of steam pans over a heat source, increasing in sugar concentration and decreasing in water after progressing through each pan.

Graafland Engineering supplied an evaporator of 1,200 l per hour capacity.

By the use of an oil treatment program using Envirotemp which is added to the refrigerant side of the system, it will remove stagnant oil layers within the condensers and evaporators of the refrigeration system.

A variation of Flavourtech's standard Centritherm ® evaporator, Centritherm ® High - Vacuum evaporator achieves higher vacuums and temperatures than the standard unit.

Flavourtech's Centritherm ® evaporator technology is used for concentration of high - value or viscous juice products for maximum flavour and colour.

Flavourtech's Centritherm evaporator is an ideal unit for the concentration of extracts containing bio-active compounds.

The purchase and installation of a $ 2,800,000 grape juice evaporator at our Berri site has opened up new opportunities for the business.

The liquid concentrate constitutes a small wastewater stream, recycled to add to the fresh solid waste in the slurry - making stage, or recycled to a TAR pre-treatment, disposed of in a conventional anaerobic / aerobic or aerobic wastewater treatment plant, or treated in a dedicated wastewater treatment plant (RO - concentration / evaporator).

To research the tome, he and a team of 50 chefs, writers, and photographers spent five years conducting detailed tests, many of them involving liquid nitrogen, rotary evaporators, centrifuges, and other industrial paraphernalia.

The liquid solvent is circulated through a bed of moist, green coffee beans, removing some of the caffeine; the solvent is then recaptured in an evaporator, and the beans are washed with water.

Evaporators the size of small cars can each desalinate almost 140,000 gallons of seawater a day to provide freshwater for passengers and staff.

The capabilities of Test Cell 1 include a fuel / air combustion skid for energy input; cooling systems for heat removal; 130 kW eddy - current dynamometer for precision power measurements; and instrumentation, system protection, and power control channels.For measuring the thermal output of fuel - fired thermal energy systems, such as a gas - fired liquid - metal evaporator for Stirling engines, Test Cell 1 offers a gas - gap calorimeter, which simulates the engine by allowing the liquid metal to condense at operating temperatures.

A quadruple - effect evaporator, by definition, will produce four pounds of condensate (essentially salt - free water) for each pound of steam yield.

Every few weeks, they pump sea water from the ocean into a plastic tank, drive it back to their farm, and funnel it into a 76 - by - 12 evaporator Curtis built on the outskirts of their property.

Your AC evaporator condenses water when the warm moist air passes over it, this happens in the normal operation of the AC.

A clog in the evaporator hose will also result in a lot of moisture accumulating inside the cabin when the AC / defog is running.

«So, using laws of physics... you can tell if the refrigerant is in liquid form when leaving evaporator and entering the compressor (which would be bad for the compressor).»

Evaporator Canister Purge System - The GM service manual points to this as the typical cause of «dieseling».

by changing the superheat and subcool numbers higher or lower (by adding or removing freon), you're moving the position of the where the evaporation / condensation point happens further up or down in the evaporator or condenser from top to bottom.

When the blower is on low and lets say flowing one gallon of air a second, the evaporator is able to drop its temperature from 87 to 42 degrees.

They can clean the evaporator and other parts, but if its in the ducts it might keep coming back if they don't get rid of it all.

32 PSI (guess you actually mean psig) low side matches to a R134A boiling point (close to the actual evaporator temperature with newer evaporators) of 2.71 °C, slightly above water freeze point, and won't mean much until we know if it's variable displacement or not.

By a similar reasoning, since the cooling capacity of the system is influenced also by the airflow over the evaporator at a present time (along by the flow of liquid refrigerant through it and its exchange surface), the cabin's temperature is influenced by the fan speed.

The bulb is physically buried in the evaporator core, and reads the temperature of the core by thermal conductivity.

Nevertheless, the overall amount of work done by the system is ultimately dictated by the temperature and flow across two heat exchangers, the evaporator and the condensor.

The long answer is: provided that the ambient's air is well above the freezing point of water, that the cabin's air filter is clean and that the system is set to cool ambient air and not recirculated one, the evaporator's thermal load is proportional to fan speed, and, therefore, air volume.

If a smaller mass of air has to pass through the evaporator, less energy ends up in the refrigerant liquid, so the evaporator cools down faster.

It appears that the actual spring is gone from the spring lock fitting that connects to the evaporator so I guess now I'll have to figure out how to get another hose since the system was a packaged R134a conversion kit... Is it at all possible to evacuate the system of all oil myself or is that something I'll need to go to a shop to have done?

With a TEV system, the spring inside the TEV allows a certain superheat value to be maintained, and the sensing bulb in contact with the evaporator's outlet raises the valve's needle allowing more liquid refrigerant inside the evaporator when the outlet becomes warm and less when it becomes cold, all of this resulting in a vapour with a certain superheat and pressure at the evaporator's exit and therefore in the suction line.

Another useful purpose of the TXV is to prevent evaporator icing, which has a runaway effect if left unchecked.

If a larger mass of warm air has to pass through it, more energy is transferred, through the evaporator's fins (so that even the evaporator's design and, in particular, its exchange surface play an important part) from the air to the liquid refrigerant allowed inside it by the TEV or orifice tube so it expands more and, along with the absolute pressure inside the evaporator, the refrigerant's vapor superheat (the delta between the boiling point of the fluid at a certain absolute pressure and the temperature of the vapour) increases, since after expanding into saturated vapour, it has enough time to catch enough heat to warm up further by vaporizing the remaining liquid (an important property of a superheated vapour is that no fluid in the liquid state is carried around by the vapour, unlike with saturated vapour).

A dirty cabin air filter restricts the air flow around the evaporator core (the cold part of the A / C system) reducing its effectiveness.

While wrenching on the starter, my hand struck a small hose and it broke the nipple of (what I think is) the Evaporator Purge Control Diaphragm (EPCD): I am investigating alternatives to replacing...

What I would expect to see is a distinct puddle of (possibly nasty) water underneath the evaporator drain hose.

now my a / c blows hot air i put die and had a tech check he did not find any leaks at all so he asked another tech that works for dodge and was told it is the evaporator for SURE the evaporator used in my vehicle are the worst and it should be a recall, but of course Dodge said no again.

An after warranty recall was done on the rear evaporator of the AC system and that unit was replaced.

In these works, the expressionist brush strokes of his early paintings are replaced by the effects of a vapor evaporator, a piece of specialized machinery that allowed Bell to apply subtle gradations of translucent color.

The latent cooling capacity of the air conditioner is the amount of heat absorbed when water vapor condenses on the evaporator coil (see photo at right).