Unfortunately, I ran out
of hem tape and had about a foot of curtain left to hem so I tried fabric glue instead (cause I don't sew) and it didn't work nearly as well.
Directly under the pin line, apply a strip
of hem tape.
It required a few rolls
of hem tape, but sometimes I prefer not to have stitching lines.
BE SURE to follow the directions
of the hem tape for the hemming process.
Then wrap that inch
of hem tape and velvet ribbon at the bottom into the inside of the pant and secure it the same way as the rest, with heat.
Not exact matches
For a pro touch, I recommend that you also get 130 cm
of 2 cm bias binding
tape with which to enclose the
hem seam allowance (see Step 7).
I walked all over the store in search
of the adjustable
hem tape, finally looking it up on the site and then walked right to aisle D4.
Handmade mixed lace Edwardian jacket or blouse in off white... Combining fine quality
tape lace with needle lace and a
hem of Milanese lace this is a beautiful example
of the lace makers...
Take your measuring
tape and measure the edge
of the asymmetric
hem of the skirt all the way around.
Fashion
tape is amazing, I actually used some
of it today to faux «
hem» my pants, haha!
Instead
of hemming them with fabric
tape or a sewing machine, I simply use pinking shears to cut the edges.
I did a baby
hem on this skirt rather than
hem tape like last time»cause I knew you might be able to see the underside
of the skirt because I made this skirt with a slight hi - lo
hem.
To check the length, go around the circle with the measuring
tape and make sure it matches the
hem of the skirt.
Whip up a no - sew bandana with some cute fabric and fabric glue... MORE or
hemming tape, or a no - sew tutu with elastic and strips
of tulle.
Apply
hem tape to the entire unfinished curtain panel edge... the whole length
of the shower curtain panel and attached decorative fabric.
Referring to the photo, above, for placement, hand - sew rickrack and twill
tape to the
hemmed edge
of the towel using matching sewing thread and tiny tack stitches.
Apply iron - on
hem tape (I like Heat N Bond UltraBond Iron - on Adhesive) to one side
of each fabric panel with the 7/8 ″ seam allowance.
Note: Fabric glue or even
hem fabric
tape would be a great option, but for this experiment
of mine, the hot glue seemed to work just fine.
I bought curtains from Ikea TODAY and have been struggling all day with their measure / iron / sticky
tape method
of hemming (I got only one
of four panels done and it leaves much to be desired!)
roomies this year, Handmade Business Card Holders To accompany them, I also made each
of the girls a super easy, No - Sew Fabric Key Fob To make your own, you'll need the following supplies: 2 fabric pieces cut 10» x 2 1/2» key fob hardware -LCB- found mine on Amazon -RCB-
hem tape -LCB- I used 5/8» roll -RCB- pliers iron Now,... [Read more...]
The first time I did this, I used a no - sew
hemming tape and lots and lots
of glue.
Make sure you purchase enough to run the length
of your table, and
hem the edges using a sewing machine or
hem tape.