Hello, we are trying to sell our house and we had a home inspection done and there was no structural damage, there are no cracks in the walls anywhere, it has a few cracks in the tile in the kitchen and the foyer, it is
on a slab foundation.
Not exact matches
It rests
on a concrete barge — the floating equivalent of a crawl - space or concrete
slab foundation that can be found under rural or mid-century land - built homes.
1 As work progresses
on the
foundations, a plate compactor is used to ensure a solid, stable base for the concrete
slab; 2 pouring the concrete
slab; 3 a cross-section of the wall build - up showing wet dash finish followed inside by external insulation, 215 mm solid block walls, sand - cement plaster and insulated plasterboard internally; 4 airtightness detailing around joist ends; 5 pro clima Intello airtightness system under counter battens to create a service void while minimising airtight layer damage by service penetrations; 6 a parge coat serves as the airtight layer
on the inner face of the single leaf block walls.
Pour a driveway to park
on, put in the
slab or
foundation, eventually build the kit in 5 - 10 years.
The
foundation wall is insulated with 2» foil - faced polyisocyanurate rigid insulation
on the interior and the
slab is uninsulated.
Concrete floor
slab on insulated foundation system (300 mm of EPS)(Kore Passive Sl
slab on insulated
foundation system (300 mm of EPS)(Kore Passive
SlabSlab).
Foundation Assembly:
Slab - on - grade foundation; uninsulated with Termimesh ® termite mitigation system and sill gasket between framed wall and s
Slab -
on - grade
foundation; uninsulated with Termimesh ® termite mitigation system and sill gasket between framed wall and
slabslab.
One place to start is requiring that vapor impermeable waterproofing be used
on foundations and basement
slabs.
Forming a thermal bridge free junction between the base of the external wall and the ground
slab /
foundation is a challenge that occurs
on many Passivhaus projects.
Infiltration: Air barrier system is as follows: existing basement
slab with two coats of epoxy paint; taped rigid insulation
on inside of
foundation walls; spray foam at the rim joist; taped housewrap
on above grade walls; fully adhered membrane
on existing roof sheathing; transitions between roof and above grade walls made by lapping membrane over the housewrap; other transitions made using sealant.
That can be handled within the code (permanent wood
foundations,
slabs on grade with anchor points, or using the Alternative materials, design, methods of construction and equipment» clause within the code).
«The thing about the Passive
Slab is that it's a floating
foundation which instead of sitting
on the ground is sitting
on a layer of impervious insulation, sitting
on stone.
While a home inspector can tell you if your home was built
on a
slab or raised
foundation, a
foundation engineer can tell you if the home is sliding or the
foundation is faulty.