1 adjustable utility shelving 2 lockable cabinet 3 pegboard for tools 4 plastic bins for long - term storage of paper or other items that don't require air circulation 5 covered garment racks 6 canvas garment bags and boxes 7 large hooks to mount
on joists if in an unfinished basement (never from pipes, as weight could damage them) 8 stepstool
Relying
on the joists to shoulder the brunt of the load means that this floor top can be practically anything you like, as long as it performs a few basic duties like resisting foot traffic.
Centre the short end of the panels
on the joists so you have something to attach the next panel to, and keep going until you've covered the wall.
Not exact matches
The project is a typically finicky downtown venture: the early - 20th - century structure occupies almost the entire property it sits
on, so the materials and heavy equipment have to be shoehorned in via a narrow alleyway or, in the case of massive new roof
joists and pipes, through the roof.
Much emphasis was placed
on the importance of building a strong foundation, which usually involved employing materials like the «concrete» of absolute truth, the «
joists» of biblical inerrancy, and the «bearing walls» of Christian doctrine.
On the other hand, if you are thinking about a wall or ceiling mounted pull up bar, you need to make certain that the space has the
joists that are needed to properly and safely secure the bar.
Modular Home: A home constructed
on an assembly line
on conventional home floor
joists and delivered to the site
on a trailer.
Start by laying the drywall
on the floor and marking the location of the
joists with a pencil.
Structural Problems After gathering evidence, the plaintiffs focused much of their attack
on the fact that Smith failed to note significant structural problems in the basement, including a missing king jack stud, missing structural headers, and large holes through
joists, and more.
The rim
joist is insulated with cavity insulation
on the interior and the slab is left uninsulated.
In Basecalc, the rim
joist is not considered, (but this was analyzed in past research, Straube and Smegal 2009), but thermal bridging across the top of the foundation wall is considered depending
on above grade wall construction.
Walls framed with standard 2» X 4»
on 16» center stacked
on top of floor
joists for added strength for roof.
Outside to inside: Open vinyl mesh, 6» mineral wool, 7.5» cellulose inside existing 2x8 floor
joists, 3/4» taped plywood or Henry's Blueskin
on top of existing rabbeted fir subfloor for air tightness.
Outside to inside: metal standing seam roofing, WRB, 1/2» plywood, 2x4
on short side purlins, 5/8» Agepan sheathing, 9.5» I
joists filled with cellulose, 1/2» plywood taped for air barrier, 2x12 roof
joists filed with cellulose, 5/8» drywall.
U-value: 0.13 W / m2K ROOF Before: 200 mm fibreglass wool insulation
on the flat between roof
joists.
The rim
joist is insulated with cavity insulation
on the interior.
1 As work progresses
on the foundations, a plate compactor is used to ensure a solid, stable base for the concrete slab; 2 pouring the concrete slab; 3 a cross-section of the wall build - up showing wet dash finish followed inside by external insulation, 215 mm solid block walls, sand - cement plaster and insulated plasterboard internally; 4 airtightness detailing around
joist ends; 5 pro clima Intello airtightness system under counter battens to create a service void while minimising airtight layer damage by service penetrations; 6 a parge coat serves as the airtight layer
on the inner face of the single leaf block walls.
Rim
joist assembly must be insulated with air impermeable insulation or insulated
on the exterior
It is built with 2 × 4 construction
on a custom steel trailer with steel floor
joists, aluminum rodent resistant underside, radial tires, safety brakes and four leveling jacks.
200 mm concrete structural slab, 22 mm particle board
on baby
joists as floor finish.
1 Oscar Baldry getting down to work in the old newsagent's shop; 2 laying Kingspan and Ecotherm insulation in the ground floor of the old shop; 3 first floor metal web
joist detailing, with membrane behind the
joists for airtightness; 4 ground floor walls feature 50 mm Xtratherm internal insulation; 5 this is followed inside by an Intello vapour control barrier and a further 25 mm Xtratherm; 6 the new timber frame first - floor twin - stud walls and roof rafters are of a fully breathable construction and full - filled with Warmcel cellulose insulation; 7 holes in the timber - frame where the Warmcel insulation was pumped in; 8 a pro clima Intello membrane
on the inside of the first - floor walls and roof; 9 and finally, 50 mm Thermafleece (sheep wool) lined service cavity to the interior.
Roof: Roadstone black concrete roof tiles,
on 50X35mm battens, followed underneath by breathable Pro Clima Solitex underlay, attic trusses as designed by Shannonside Engineering fully fitted with 100 Knauf Ecose insulation, fitted between
joists with another 150 mm criss crossed over, with a final layer of 100 mm crossed over.
Flat roof: 50 mm pea gravel finish
on Geotextile membrane,
on Resitrix EPDM single ply membrane,
on 75 mm Dow Roofmate insulation,
on 22 mm WBP plywood,
on 200 x 50 metal web
joists at 400 centres, with 200 mm mineral wool fitted between metal web over Intello with sealed joints,
on 12.5 mm plasterboard and hardwall skim coat.
The exposed surface of the fiberglass batt insulation is below the dewpoint temperature of the air in the crawlspace as is the exposed portion of the wood floor
joists and condensation forms
on both the surface of the insulation and the surface of the exposed wood.
They are positioned
on the first floor of each house and the MVHR inlet and exhaust pass through the roof, with supply and extract fitting within a compact service void just below the trusses, or within the space of the metal web floor
joists.
Infiltration: Air barrier system is as follows: existing basement slab with two coats of epoxy paint; taped rigid insulation
on inside of foundation walls; spray foam at the rim
joist; taped housewrap
on above grade walls; fully adhered membrane
on existing roof sheathing; transitions between roof and above grade walls made by lapping membrane over the housewrap; other transitions made using sealant.
This video shows the floor being attached to a custom built Tiny House steel trailer, but the same principles apply if you are installing
on wooden
joists.
Roof: Rheinzink Prepatina graphite grey double standing seam onto 22 mm plywood sheeting,
on 44 mm battens fixed through to
joists,
on Ampatop Protecta plus roof membrane,
on 500 mm twin timber stud warm roof fulfilled with Springvale Ecobead Platinum insulation,
on Siga Majpell vapour control and airtight layer,
on 15 mm OSB class 3 board,
on 45 mm service cavity fulfilled with mineral wool insulation,
on 12.5 mm plasterboard with 3 mm skim coat finish
U-value: 0.12 Flat roof: Kaliko PVC - P membran
on WBP plywood
on firing
joist on Ampac's Ampatop Protecta membrane
on 500 mm twin
joist 150 mm top and 100 mm bottom.
Roof: Roadstone black concrete Donard roof tiles,
on 50X35mm battens, followed underneath by breathable Pro Clima Solitex underlay, attic trusses as designed by Harmony Timber Engineering fully fitted with 200 mm Knauf Ecosse insulation, fitted between
joists with another 150 mm criss crossed over, with a final layer of 100 mm crossed over.
It's built
on wooden skids with
joists and steel hurricane ties.
If you have a property that wasn't renovated to actually be a duplex, you probably just have 1/2» drywall
on the ceiling with empty
joist cavities.
These include Delta
Joist [TM], a unique building and roof support subsystem that enables Butler's MR - 24 [R] standing seam metal roof system to be used
on load - bearing hardwall construction.
Or concern about the Live and dead load
on the floor
joists?)
Most of whom knew / know NOTHING about 2 x 6 construction,
joist hangers, well windows, an add -
on room that was built
on pylons where carpet ants had eaten the wood beneath, not a regular basement; a basement wall that was all but heaving and freshly painted, to cover up problem (evidence in cold cellar — a gallon container of sealant and paint that colour left
on display — duh!)
Project Description In a style and location appropriate to the existing house, add a 16 - by -25-foot room
on a new crawlspace foundation with wood
joist floor framing, wood siding
on exterior walls, and fiberglass shingle roof.
If there is a crawlspace, they'll get down
on their hands and knees and crawl through the entire thing, looking at the foundation posts, beams, and
joists.
If it wasn't properly anchored to the
joists, there might be enough give in it that when you walk
on it, the grout gets loosened, even if the tiles are in solid.
«A contractor can install a plastic, vinyl shield
on the existing
joist and remove the ground cover.
While the termite inspector did not discover any termites, he did discover dampness in the crawl space as well as fungi growing
on the floor
joists in the crawl space.
They approached me, leaving the crawl space as I watched them and as I said clearly, «be careful don't bump your head
on the overhead floor
joists,» I couldn't help but see the Mr. had lost all his colour.
Problem is I still have all these pin size wholes in
joist that bother me and could be a problem
on a wdo down road.
From revealed
joists through to exposed ceiling ducts, warehouse conversions wear their hearts
on their sleeve.
But I was wondering, did y ’ all end up using liquid nail glue
on the planks that couldnt be nailed to the
joists?
For example, the thickest planks, at about 22 mm, can be laid over
joists as structural floorboards, while thinner planks, at about 7 mm to 15 mm thick are laid as overlay floors
on to an existing smooth, dry sub-floor.
This method of laying a sturdy subfloor
on top of
joists and then topping the subfloor with a cosmetic - only flooring top creates a tighter, stronger structure.