Sentences with phrase «one on each axle»

The 7,000 figure includes the 450 jobs on axle production, 1,500 jobs tied to the $ 1 billion announcement and more than 5,000 new jobs tied to engineering, GM Financial and advanced technology.
For the faithful, day after day world affairs fell into place like the clink of a lug - nut on an axle bolt.
It turned out that he had climbed up under Bill's station wagon, which was parked at Stanton's garage, and had ridden 10 miles to the dump and then back to Stevens» house, all the while perched on the axle rod or the distributor.
If one is bad then its diagonally opposite number should also be replaced, but that then means you have an old unit and a new one on each axle, so you should ideally replace all of them.
To check, jack the front of the car up and support on axle stands.
We come across numerous lorries sitting on their axles.
«Tip the car into a corner and the front end bites hard before the weight settles evenly on both axles.
In some vehicles the hand brake operates on a drive shaft which means both wheels on that axle need to be on the ground for it to work, lifting one would allow an open differential to rotate.
The new ML63 also includes a newly - developed Active Curve System, standard on all AMG MLs, stabilising body roll by using active roll bars on both axles.
Remember, torque is the engine working on the axles and, thereby, the wheels and tires.
With a motor on each axle, the I - Pace eTrophy will produce a total of 394bhp.
Additional # 1 When I checked the pads to begin with I found that the rotor was sitting loose on the axle and that all that was holding it in place was the wheel and that with the wheel being removed the rotor could move a fair bit on the wheel bolts and was only being retained at that point by the brake caliper.
Based on the same MEB platform as the Skoda Vision E and the other I.D concepts, the Crozz is claimed to be capable of around 310 miles on a single charge, deployed through electric motors mounted on each axle.
The engineering of this ultramodern car is absolutely unreal: a monocoque built from carbon - fiber - reinforced plastic; a racing - type weight distribution of 43 percent front / 57 percent rear; rear tires that are each over a foot wide; a plug - in hybrid powertrain with electric motors on each axle that delivers 19 miles of range in full - electric mode; a seven - speed PDK transmission; and a 4.6 - liter V - 8 engine that revs to 9150 rpm and makes 608 hp.
«the rotor was sitting loose on the axle and that all that was holding it in place was the wheel» - That's OK.
You will want to weld the ends (around the exterior on the end) on each side on the axles.
Similar to the concept, the production - spec C - X75 should have a small - displacement gasoline - powered engine paired with an electric motor on each axle, and be able to go about 31 miles in EV mode.
I'll be replacing the CV boots on my axles pretty soon and was wondering what the best way to clean the old grease off is.
At # 1220 it was pretty reasonable, especially considering that the eye - wateringly expensive pads on both axles were changed.
Could the hoses on the axle still have air in?
Same for the other tire on that axle.
On each axle will sit an electric motor, generating a combined 592bhp power output.
Front and rear spring rates are up 30 per cent, the dampers — which adjust 100 times per second — are retuned and there's been a whole host of hardware changes on both axles, too.
If you need to replace the tire, then like everybody else, change the 2 on that axle if your other 2 tires are still in good shape.
Technical specs have been revealed and at launch the I - Pace will be powered by a combination of two electric motors, one on each axle, producing a combined 394bhp and 514 lb ft of torque.
I'd recommend replacing both tires on that axle, but not all four unless they are as bald as that one appears to be.
The Outlander plug - in hybrid uses a 2.0 - liter four - cylinder gasoline engine paired with dual 60 - kWh electric motors, one positioned on each axle.
The D refers to «dual - motor» and means those cars are four - wheel drive, using a motor on each axle.
That means the AMR Pro does away with the Valkyrie's 20 - inch front and 21 - inch rear wheels and has 18 - inch items on both axles.
It weighs a rather corpulent 2108 kg, but, with a motor working on each axle, it does have all - wheel - drive traction.
The VW I.D. Crozz, due in 2020, will be powered by a pair of electric motors, one on each axle, with a combined output of 302 hp.
As technology evolved, 4MATIC moved with it, morphing from a part - time system to a permanent all - wheel drive setup that utilized a mechanical center differential to transmit power from the transmission to both the front and rear tires while front and rear diffs provided traction to the left and right tires on each axle.
Its physical position is on the usually on the axle of the driven wheels — at least in its most basic configuration — essentially splitting the driven axle into two parts.
There's also extra underbody protection for the brake and fuel lines, electronic differential locks on both axles to help you to get moving on slippery surfaces and an off - road mode that acts as a kind of slow - speed cruise control for creeping over rough terrain.
Based on the cutesy 500, this diminutive hot hatch receives a stiffer suspension on both axles, a turbocharged 1.4 - liter four - cylinder that makes a stout 160 horsepower, and, of course, bigger brakes to keep the extra grunt in check.
The most common locations for the ABS speed sensor are at a wheel or on an axle.
The PDCC motor applies and releases torque to its stabilizer bars on both axles, countering excessive body movements while not compromising the suspension's independent movements in all driving conditions.
The improved downforce on the axle and reduced weight with the aid of the carbon fiber elements does make the car more stable at high speeds.
The Frankfurt concept has two electric motors mounted on each axle, the total power of the assembly being estimated at 275 hp and 500 Nm.
While the EV remains a total mystery, the DS 7 Crossback E-Tense 4x4 pairs a 1.6 - liter turbocharged gasoline engine with two electric motors (one on each axle) and a 13 - kWh battery.
If the truck does not have leaf springs on the axle does possible that it has an arm that acts as a control arm that...
The latest 7er comes equipped with Dynamic Damper control and air suspension on both axles, rather than just the rear axle.
For the SUVs we expect one electric engine on each axle, which will deliver a 4wd electric traction.
These prototypes featured a 1.6 - litre turbocharged and supercharged inline - 4 engine coupled with two YASA electric motors placed on each axle of the car.
This enables both wheels on the axle to transfer more power to the road.
The manufacturer also claims pseudo transverse differential locks on both axles to go with the longitudinal one by virtue of the electronic differential system (EDS), integrated into the stability control, that brakes a slipping inside wheel, letting drive make its way uninterrupted to the opposite side.
Steering is another area of improvement, as engineers mounted the steering box farther forward on the axle for better weight distribution.
The all - wheel - drive system uses differentials on both axles and in the center of the car, allowing a wide range of torque distribution to get power to the wheels that need it most.
Today, Schwarzenegger and Kreisel Electric unveiled an all - electric Hummer H1 soft - top prototype, equipped with electric motors on each axle, 100 kWh worth of batteries, a 75 - mph top speed, a 186 - mile range, and a ludicrous 7275 - lb curb weight.
The front axle gets special steering knuckles and load - bearing joints, as well as a more negative camber on both axles to enhance lateral dynamics.
a b c d e f g h i j k l m n o p q r s t u v w x y z