Not exact matches
Take a
piece of string,
ribbon, thread, or a thin strip of paper and wrap it around your finger, close to the knuckle.With a pen, carefully mark the spot where the string
overlaps with its end and either hold it up to a ruler that has millimeter measurements, or to the graphic below.Use the chart to determine your ring size.
Next, cut a
piece of
ribbon long enough to go around the jar and
overlap slightly.
I eye - balled how much burlap
ribbon I would need, making sure that the
ribbon overlapped in the back so I could Velcro the two
pieces of burlap
ribbon together.
Secure the
pieces at each end on the edge of the board with map pins, pulling them taut and allowing enough
ribbon to
overlap to the back of the board.