Sentences with phrase «part load»
Higher levels of thermal insulation and lower heat gain lead to part load humidity problems.
buildingscience.com
This section gives a brief introduction to engine operation at part load.
This section describes and compares both these methods for improving part load fuel economy.
The flat floor and a two - part loading strip made of stainless steel are practical convenience elements, combined with premium materials.
The cylinder on demand (COD) system, which deactivates four cylinders under part load, and a start - stop system make the sonorous eight - cylinder unit very efficient.
Ensured complete storeroom repair parts load out are onboard and ready for issue, prior to the shipbuilder's sea trials.
The Roots - type Eaton M62 supercharger (with a sealed - for - life internal mechanism meaning that it does not require the use of the engine's oil) is run from the crankshaft and has an integral bypass valve for part load operation.
The B - cycle combustion process (a modified Miller cycle, earlier post), which is designed specifically for part load, makes the V6 gasoline engine particularly efficient.
In engine part load, the solenoid valve is opened earlier causing partial valve openings to control the trapped air mass as a function of the required torque.
The benefits from internal EGR are two-fold: Firstly, internal EGR benefits part load fuel economy by diluting the charge within the cylinder, thus restricting output without the need for increased throttling and its associated pumping losses.
Other part load strategies.
For example, a pull - out two - part load net, rear head restraints that did not need to be removed when folding the rear backrest, and naturally also a three - point seat belt in the rear middle seat.
On part loaded condition the marginal cost of electricity from diesel generator could be higher than 20 Rs / kWh (US$ 0.31), but due to the lack of policy certainty and delays in decisionmaking, we are yet to achieve goals set up for «Greening the Islands».
The COD system activates four cylinders when under part load.
The consequence of this reduced energy exchange is beginning to be seen all over the place: mold, part load humidity problems, rot, and corrosion.
Its mechanical compressor, which provides charging, is deactivated when operating at part load.
The cylinder on demand (COD) system, which deactivates four cylinders under part load and a start - stop system make the sonorous eight - cylinder engine very efficient.
The significantly better response of a VALVETRONIC power unit results in particular from the fact that under - pressure in the part load range is only about 50 millibar, while in a conventional engine under - pressure is up to 800 millibar.
The cultivated eight - cylinder, which uses Audi's «cylinder on demand» technology under part load, consumes on average just 9.7 l / 100 km.
Under part load, it deactivates four of the eight cylinders for an efficiency gain that is particularly pronounced at moderate highway speeds.
Engineering skills and long years of experience with RS high - performance models went into further optimizing the 4.0 TFSI, from the specific engine management system with increased rpm and boost pressure to the Audi cylinder on demand (COD) system, which only activates four of the eight cylinders when under part load.
When the V8 deactivates four cylinders under part load, the Active Noise Cancellation system (ANC) is activated.
It supplements the FSI gasoline direct injection at part load to reduce consumption and particulate emissions.
Part load humidity problems lead to wetter walls.
We create something called «the part load humidity problem.»
«Displaced thermal generators operating under part load were less efficient on average and wind power also tended to be subject to larger system losses.»