Trim the end and
press under the edge of the hoop.
Not exact matches
«Fold overhang
under, and crimp
edges: With thumb and index finger of one hand, gently
press dough against index finger of other hand.
Fold 1/2 inch of crust
edge under, forming border;
press to seal seam.
The fluted
edge should be
pressed under the rim of the pan in several places to prevent shrinkage.
Gently fold the
edges under and
press with a fork or pinch into a fluted design with your fingers.
The top and bottom
edges are
pressed together, cut to a 3/4 - inch overhang, and folded
under to make the rim on the pie plate
edge.
Fold
edge under bottom crust,
pressing to seal.
Fold
edges under, and
press to seal using the tines of a fork.
Using the wide flat side of a large knife, run the flat
edge under the metal round,
pressing upwards to separate the round from the cheese.
Make sure you
press well the crust into the bottom and
edges of the pan so no filling gets
under the crust.
Press crust
edges together, then fold
under.
Fold the excess dough
under itself and use the tines of a fork to
press the dough against the
edge of the ramekins.
Fold
edges under, and
press to seal.
Fold the
edges of the top crust
under the bottom crust and then seal by
pressing them together with your fingers.
Next, lay your fabric
under the
presser foot, and zig - zag, allowing the outside of the stitch to fall slightly off the
edge.
(Turn
under 1/8» - 1/4»,
press, turn
under again to enclose the raw
edge.
Otherwise, slide your hands
under your feet and open the soles up to the sky, keeping the outer
edges pressing together.
Go over the
edges of the tape where paint will be applied with you finger to make sure it is
pressed down securely so that paint won't get
under bubbles in the tape.
I cut 1 1/2 ″ strips, and
pressed the long
edges under 1/4 ″.
On your machine lay the
edge of the unpressed end of the tube
under the
presser foot, so the body of the scarf is to the left and the raw
edge is to the right.
For the pleather details, I cut two pieces 2 ″ by 24 ″ (a little longer than my sleeve length) and lightly
pressed the long
edges under by 3/8 ″.
Press the button located
under the
edge of the license plate border (it's on the right side).
But nobody would have thought of testing the S7
Edge under a brutal hydraulic
press.
A new torture test video shows the Samsung Galaxy S7
Edge getting crushed
under a 400 - ton hydraulic
press.
I
pressed the 19»
edge under 1», and then 1» again, and
pressed it flat.
Be sure to securely
press the
edges down so the paint doesn't bleed
under the tape.
Cut a 49 cm square of contrast A fabric, fold
under a 1 cm hem on all
edges and
press.
Press under 1 cm along each long
edge on one strip.
Step 6) To create the hem, turn
under 1 cm all round along the bottom
edge and
press.
Press under 2.5 cm along the three remaining raw
edges.
Press the tie, also
pressing under the raw
edges.
Press top seam
under 1 1/4» with iron and sew 1» down from folded
edge.
Press under the two raw
edges by 2.5 cm.
Step 8) Pin the pocket centrally to the front of the apron and top stitch in place along the sides and bottom, 1 mm from the
pressed -
under edges.
Turn
under the raw
edges along each short, cut
edge, machine or hand stitch and
press.
Step 3) To hem the side
edges,
press under 7 cm along each side
edge then turn
under the raw
edge by 2 cm.
Step 4) To make the channel for the curtain pole,
press under 12 cm along the top of each curtain then turn
under the raw
edge by 2 cm.