As its hinged joints heave and fold,
they pump hydraulic pistons, which in turn spin high - pressure fluid generators.
Not exact matches
More
hydraulic fluid is
pumped into the lower compartment, which raises the
piston and in turn compresses the water — only a little, though, because water is highly resistant to compression.
Engine Type: Chevy Small - Block V - 8 Displacement (cu in): 350 Bore x Stroke (in): 4.000 x 3.480 Block (P / N 10105123): Cast - iron with 4 - bolt main caps Crankshaft (P / N 14088526): Nodular iron Connecting Rods (P / N 10108688): Powdered metal steel
Pistons (P / N 12514101): Cast - aluminum Camshaft Type (P / N 24502476):
Hydraulic flat tappet Camshaft Lift (in):.435 intake /.460 exhaust Camshaft Duration (@.050 in): 212 ° intake / 222 ° exhaust Cylinder Heads (P / N 12558060): Vortec iron; 64cc chambers Valve Size (in): 1.940 intake / 1.500 exhaust Compression Ratio: 9.1 nominal Rocker Arms (P / N 10089648): Stamped steel Rocker Arm Ratio: 1.5:1 Water
Pump (P / N 88894341): Cast iron, long - style Flexplate (P / N 14088765): 12.750» Recommended Fuel: 92 octane Ignition Timing: Base 10 ° BTDC, 32 ° Total Maximum Recommended rpm: 5,500 Balanced: External
The
hydraulic pressure to the servos is supplied by a high pressure radial
piston hydraulic pump.
The newly choreographed hood has resulted in an opening time of only 14 seconds due to a new five -
piston hydraulic pump.
Also see Steel Braided Hoses Brake Lining Material: A composite of matrix binder, metallic or ceramic particles and friction material that also coats the disc surface Brake Pads: The pad consists of a steel backing that fits into the locking mechanism of the calipers and a layer of about 10 mm of friction brake lining Brake
pistons: Is a
hydraulic actuated
piston that transfers the
hydraulic pressure from the master brake
pump to cause the brake pad to bind with the disc.
All internal engine parts including
pistons,
piston rings,
piston pins, crankshaft and main bearings, connecting rods and bearings, camshaft and bearings, timing chain / belt, timing gears, intake and exhaust valves, valve springs, valve guides, oil
pump, push rods, rocker arms, rocker arm shafts,
hydraulic and solid lifters, intake manifold, distributor shaft and housing, harmonic balancer, timing gear cover, and vacuum
pump.
All internally lubricated parts: Engine block, cylinder heads, intake manifold,
pistons,
piston rings, wrist pins, connecting rods and rod bearings, timing chain and gears, valve covers, rocker arms / shafts and bushing, valves, valve springs, seats and guides, valve push rods,
hydraulic valve lifters, oil
pump, oil pan and fuel
pump.
Hydraulic lifts have fluid in them, and moving the lever in half
pumps down increases the pressure on the fluid, forcing the
piston up and lifting the tabletop.
The company's wave - power system acts as a sort of
hydraulic pump that converts the vertical motion of waves into pressurized sea water, which in turn drives a
piston that forces sea water through a turbine.
A perhaps simpler approach is to use wave motion to power
hydraulic pistons, as with the Sea Dog
pump developed by Independent Natural Resources Inc in the USA www.inri.us.
The wave system is based on a
hydraulic power take - off system, using a double function
piston pump to transform the energy from the wave into water pressure that is then sent through a turbine, thus generating electricity.