There are no measurements in the instructions for where the new mounting bracket plate is located other than
rear bolt hole should be lined up with the rear mounting hole for the factory transfer case skidplate.
Not exact matches
I could
bolt or weld a $ 30 Class III receiver to the steel bumper, and either cut an access
hole in the plastics (plastics are already damaged) or drive with the
rear bumper plastics off.
The rubber / plastic bungs for the threaded
bolt holes are then obvious under the line of the
rear seat back, and comparatively easy to remove with a screwdriver.
On 2009 and later Legacy vehicles equipped with VA1 - type
rear differential, the style of the
rear differential filler and drain plugs has changed from a hexagon
bolt to a hexagon socket
bolt, along with the size of the
holes in the
rear differential cover.
There is one small rust
hole in the right
rear cab brace that is about the size of a dime and one small
hole in the driver's side area where the door sill plate
bolts down.