You do not want to test cylinders by
removing plug wires.
Not exact matches
I
removed the plastic cover on the valve cover and pulled the
plug wires to access the
plugs and was surprised to find oil pooled around two of the
plugs.
Remove plug from engine Place
plug into coil
wire Make sure threads of the sparkplug are grounded to a metal surface.
This will cover
removing spark
plug wires, cleaning spark
plug wells, installing and torquing spark
plugs, and reinstalling
wires.
Remove your
plugs, check the gaps, refit them to the correct torque and make sure all of the
wiring to the
plugs and associated coil (s) are firmly and correctly connected.
2 - ignition voltage comes to the spark
plugs (
remove one of the s.plug caps and hold it close to a metal surface on the engine and ask your friend to crank the engine to see if spark exist) If there is no spark, refer to the car manual (ignition system
wiring drawings) to see related fuse / relay / diodes.
Before this, while putting
plugs &
wires in back I
removed the coil pack.
Remove the radio and install the integration module and video switcher into the factory
wiring, this part is
plug and play.
Instead of trying to
remove the sensor in each unit bearing while the unit bearings were still attached to the vehicle as the Dynatrac instructions directed, Cory disconnected each ABS sensor from its
wiring at the nearby
plug,
removed each unit bearing, and worked on
removing each ABS sensor with the unit bearing on the bench.
Using the pry tool carefully pry the
plug «s connection piece up and
remove the
wire out of the channel.
Each pendant has UL listed parts and comes with a metal ceiling cap and 6» cord with a
plug that can be
removed for professional hard
wiring.