Sentences with phrase «tight bends so»

We slowly manoeuvred through the terrain, going wide on tight bends so that the rear didn't get caught up.

Not exact matches

However, there has been that reported bending problem, so those who like to carry their phones in tight pants pockets should beware.

Keep the top rail of the wrap tight at all times and bend over so that your baby won't fall off your body.

The look of it is by far the nicest I've found and love it when I try it on but I thought I'd be able to use it from newborn, but his head seemed far away no matter how tight I fitted it, and when he fell asleep his neck was all bent over and he ended up with his face flat on my chest so I couldn't see it.

To see if your ankles are too tight, Reavy suggests this test: Stand with your toes 12 centimeters (about 5 inches) away from a wall, and then try to bend your knee so that it touches the wall.

That being said, the responsibility for bending the knee and extending the hip falls mostly on the hams, so training hard and heavy with weak and too tight hams will most likely result in hamstring injury.

Here's how to do it: Stand with your feet together, bend your knees enough to connect to those inner thigh muscles, stretch your arms out to your side, take one arm and cross it over the other and press the palms together, bend your knees a little deeper now and take the opposite leg and squeeze it tight so those inner thighs are wrapped together, if you can wrap your leg around the bottom ankle do so, keep squeezing those inner thighs the whole time to help you control this move, find that focus and take a deep breath in, come up to stand and repeat it on the other side.

Keeping arms raised and abs tight, step your left foot back and lower into lunge position so front knee is bent at 90 degrees and directly over your ankle.

Substitute standing rapid hip extension (hands on wall, chest up, rapidly extend your right hip back with slight bend in your knee, holding your TA tight so that it is pure hip flexion and no lumbar extension.

Place your hands about 6 inches apart with a thumbless (false) grip. - Step back a few feet, letting your body straighten out as you do so. - Keep your abs tight so that your body stays supported - Now lower your entire body forward, bending only at your elbows, so that your head ducks under the bar as though you are trying to do an overhead tricep stretch. - Keep your elbows tucked in close the whole way. - Keep your entire body tight and stiff.

was feeling weak because my muscles were so tight couldn't even bend my knees into childs pose w / o pain.

so then, whenever you bend forward and create flexion in the spine, you're risking disc injury or only when the hamstrings are tight?

So in my opinion rolling up would be more likely to exacerbate the situation then help it, since when your hamstrings are really tight, most of the curve in the forward bend would come from your lumbar spine.

You wrote - «If your hamstrings are tight you are risking disk compression any time you bend forward...» so if the hamstrings are not tight, there still will be flexion in the spine when you bend forward..

I can wear a normal strapless bra with this one and it doesn't show, It's not too loose so when I bend over everything is not on display, but it's also not too tight either which is nice for overindulging or a bad sunburn.

Although these fit a bit tighter in my legs than what I usually wear, the rise is higher so they don't slip down in the back when I bend down.

And eben in XL the sleeves of Zara clothes (especially blazers) are so tight that you won't even be able to bend your elbow.

One negative I'll note is that while they're comfortable, there's no way to cinch them tighter if your waist is smaller than your hips — so if you're sensitive about bending over and showing your bum (which for some reason seemed like it became a bigger issue after kids — maybe because I was always kneeling on the floor to play with them)-- then these may not be the pants for you.

By using that process, the granite (or other stone material) can actually be bent around tight radii so that the resulting trim piece for the instrument panel or console appears to be a piece of stone with rounded edges an eighth or more of an inch thick.

The dynamic cornering light function swivels the main headlights towards the inside of a bend, based on steering angle and road speed, so as to light up more of the road at tight bends and turns.

So, while the F - Pace feels great around sweeping bends, it just can't match the agility of the Macan around tighter corners.

OK, so there's a touch of body roll on tighter bends but there's so much front - end grip from the 19 - inch 245/40 Bridgestone Potenza RE050A tyres that it makes little difference to corner entry and exit speeds.

With the Rebel being so big, the $ 595 option package that adds a back - up camera and rear parking - assist sensors is a good investment to prevent causing any bent sheetmetal in tight parking lots.

The city of Empire Bay may not have side activities around every bend, although the story is so solid that many will be able to ignore or at least forgive this tight and unwieldy structure.