Sentences with phrase «to replace the valve»

"To replace the valve" means to remove a damaged or dysfunctional valve and put in a new one. Full definition
If that happens, you need to replace valve stem seals and piston rings.
What would the ball - park cost for replacing the valve seals and piston ring be?
If you express less frequently, replace valve membranes every 8 weeks.
To ensure the best performance of your breast pump, we recommend replacing valves every 8 - 12 weeks, depending on cleaning and use.
I'm not willing to spend money on replacing the valves after so little time.
It can only be treated by replacing the valve through heart surgery and is the third leading cause of heart disease, affecting three percent of adults over the age of 75.
The cylinder head was tested at a machine shop and they also replaced the valve seals.
If you exclusively express or you express 4 or more times per day, be sure to replace your valve membrane every 2 to 4 weeks.
I've had to replace the valve seals at 90,000, the rear right window motor and a new top.
It sounds like you are talking about replacing the valve cover gasket and o - rings in the middle around the spark plug holes.
If you car does not go into drive or reverse, your mechanic is most likely talking about replacing the valve body inside the transmission.
And, as industry spokespeople like to point out, many operators have already replaced valves, improved liquids unloading processes, or otherwise modernized their equipment, so they are already in compliance and the new regulations should not impose any additional costs.
Open - heart surgery is typically required to replace the valve if it thickens so much that it causes aortic stenosis, an abnormal narrowing and stiffening of the valve.
Mechanically, it's in good nick, with recent work done replacing the valves, resurfacing the aluminum head, rebuilt water pump, and transmission service.
Though this isn't true for all in - wheel monitors, on Fords the monitor is sometimes strapped to the wheel with a metal band and just requires replacing the valve stem.
At 60,000 mile maintenance, dealer replaced valve cover gaskets and timing belt.
You will have to replace the valves with lightweight ones, purchase Monkey Wrench Racing valve springs, enlarge the oil pan, Walbro 255 lph fuel pump, and 700 cc fuel injectors.
When it failed to pass the emissions test, my mechanic replaced the valve stem seals and piston rings.
Fernando did an excellent job replacing my Valve cover gasket.
Completely eliminating all the leaks could be quite expensive, so we would advise to start from replacing the valve cover gaskets.
I didn't buy the magnetic dye, but replaced the valve cover gasket.
You should expect to replace your valves every 3 or so months if pumping regularly.
Replace your valves every 4 - 6 months, and sterilize your parts once a week.
I have two of them and have replaced the valves.
It's especially important to replace valves and backflow protectors regularly, as these silicone parts will wear down over time and lose elasticity.
The study patients received either a minimally invasive TAVR procedure — which uses a catheter that is routed through a blood vessel in the leg or chest to access the heart — or an open - heart surgery to replace the valve.
Worldwide, an estimated 300,000 people have severe aortic stenosis — a faulty valve in the main artery carrying blood out of the heart — and roughly a third of them are deemed unable to withstand the standard treatment of open - heart surgery to replace the valve.
Tens of thousands of patients each year are diagnosed with heart valve disease, and TAVR is often considered for patients who are at high risk for complications with an open - heart surgery to replace the valve.
August 2016 I had open heart surgery to replace a valve and undergo a double bypass.
They replace the valve and the check engine light has been resolved therefore passing the vehicle emissions test.
I replaced the valve, no problem.
Usually when mounting tires you replace the valve stem, on in - wheel tire pressure monitors you replace the nut, schaeder valve, and gasket.
Replaced the valve and recharge recycled the refrigerant.
So, I have replaced my valve cover gasket, as well as the spark plugs, in a 1003 Ford Tempo (apparently most of these have died already!)
Bending it back into place, removing it, welding / repairing it, or replacing the valve cover are all possible solutions given in order of increasing difficulty and / or price.
It's been suggested that, when I replace the valve cover gasket, I make sure that the head bolts are torqued correctly as they could have loosened up when the engine got hot.
And do you think it's necessary to replace the valve?
We replaced the valve and went back on the dyno only to discover the engine generated no increased power anywhere in the power curve.
I've replaced the valve the charcoal canister and still doesn't work My car has an automatic transmission.
It would be great if you make head porting, and replace valves, valve springs and valve guides.
The seller has replaced the valve cover gaskets and repainted the valve covers in Oldsmobile blue.
Over 220,000 miles, and all we've really done (besides wreck repair) is put tires on it, replace a bulb every now and then, changed the oil until this week, when we needed to replace the valve cover gasket... at 220,000 + miles.
Ideally, doctors will treat it by removing and replacing the valve.
a b c d e f g h i j k l m n o p q r s t u v w x y z