In some engines, especially for
turbine engine blade cooling and liquid rocket engine cooling, fuel is used as a coolant, as it is simultaneously preheated before injecting it into a combustion chamber.
Not exact matches
The gas
turbine operates like a jet
engine but drives a generator instead of fan
blades.
Problems with
engine turbine blades wearing out sooner than expected have hampered a restructuring programme prompted by the engineering company's declining older
engine programmes and plunging demand for oil equipment.
The technology overlaps are valuable: For example, carbon - fiber - reinforced composites developed for jet -
engine fan
blades are used in GE's wind -
turbine fan
blades, and ceramics developed for electricity - generating
turbines are used in jet
engines.
The aerodynamics of the
turbine blades affects the efficiency of the
engine, while the heat transfer from the extremely hot gas to the
turbine blades is harmful to the life - span of the
turbine.
In order to achieve the highest temperatures of 1,832 degrees Fahrenheit in
engines, metallic
turbine blades are coated with ceramic thermal - barrier coatings and actively air cooled, which together allows operating temperatures exceeding the metal's melting point.
When evaluating a part, such as a
turbine blade inside a hot jet
engine, it is important to know how each segment of the
blade heats up as hot gases flow around it.
Camci, who has worked on the method since 1989 with Steve Hippensteele of NASA's Lewis Research Center in Cleveland, Ohio, says that liquid crystals have several advantages: «The crystals are available as sheets of Mylar (polyethylene terephthalate) plastic or in liquid form, so that covering an entire piece of equipment, such a s a
turbine blade or a jet
engine duct, is fairly simple, particularly compared to applying thermocouples.
«I have never seen ash actually melting on a
turbine blade or other hot
engine part before,» he says.
Inc., which has a manufacturing facility in Livermore and has licensed an LLNL laser technology for peening jet
engine fan
blades and
turbines, and other aircraft structures, in one of the Laboratory's most successful technology commercialization partnerships.
The high exhaust flow at high
engine speeds are fully directed onto the
turbine blades by the variable vanes.
-- Isuzu COA III all - terrain vehicle with full - time four - wheel drive and a turbocharged
engine using ceramic valves, cylinders liners and
turbine blades.
An electric actuator adjusts the
turbine blades at split - second speed in response to changes in
engine loads, enabling the unit to respond with the same lightning speed at low rpm as it does under full loads.
Key
engine features for the Red Sport 400 version include a compact, lightweight aluminum - alloy
engine block and cylinder heads, Gasoline Direct Injection system, optimized
turbine blade design, an optical turbo speed sensor, high capacity air - to - water intercooler system with dual water pumps, electronic wastegate actuator, e-motor valve timing control and an integrated exhaust manifold.
Siemens has achieved a breakthrough by finishing its first full load
engine tests for gas
turbine blades completely produced using Additive Manufacturing (AM) technology.
The company successfully validated multiple AM printed
turbine blades with a conventional
blade design at full
engine conditions — the components were tested at 13,000 revolutions per minute... Read more →
Blades are modeled on the principles use in aviation props or blades in turbine en
Blades are modeled on the principles use in aviation props or
blades in turbine en
blades in
turbine engines.