For example, as part of the ongoing, international Prospective Urban and Rural Epidemiological (PURE) study, researchers
used a dynamometer to measure grip strength in almost 140,000 adults in 17 countries, and they followed their health for an average of four years.
Isometric knee extensor force was measured
using a dynamometer.
Not exact matches
«The hand - grip
dynamometer is a tool that is easily accessible, easy to
use, and is reliable,» says Jones.
Especially look for the Grip Strength Measuring Device that they
use in the video, called a
dynamometer.
The JAMAR Hand
Dynamometer (Jamar 5030J1; Sammons Preston Rolyan; accuracy 0.6 N) was
used to assess muscle function with the
use of a standardized procedure (27).
Here are the key details: Population = 1,755 institutionalised and community - dwelling Spanish people (985 females and 770 males), aged > 65 years Intervention = four different measurements of strength (grip, shoulder abduction, hip flexion and knee extension)
using a hand
dynamometer, compiled into a composite measure Comparisons = four quartiles of strength (high, medium - high, medium - low, and low) Outcome = risk ratios for mortality and hospitalisation To combine the four measurements of strength into one composite measure, the researchers
used the following calculation.
Using a hand - held
dynamometer, hip extension force can be measured with relatively good reliability.
It can be simply measured
using dynamometry by taking multiple measurements in the same
dynamometer of the same joint angle movement, at different angular velocities.
When different studies
use the same angular velocity for measurement, these can be compared to one another, so long as differences between the populations tested are acknowledged, and so long as the
dynamometer used is the same in both cases, as differences have been observed between brands (Francis & Hoobler, 1987; Thompson et al. 1989; Gross et al. 1991).
Nevertheless, Burnett et al. (2007) compared the ICC and COV of the EMG amplitude for both surface and fine wire electrodes in cervical extension between MVICs and SVICs
using an isokinetic
dynamometer.
External load types include pneumatic resistance, elastic resistance, weights (including free weights, chains, and machines), and
dynamometers (which
use magnets).
If you
use the BSFC values generated from a wheel type
dynamometer then most drag innefficiencies would be included.
The entire testing procedures
used are skewed to begin with unless we all start driving on
dynamometers.
Lastly, you'd spend ages on the
dynamometer, constantly making changes,
using different camshafts and exhaust manifolds.
WEVTU reported earlier this month that Wisconsin is ready to
use OBD - II (vehicle onboard diagnostics) in place of current I / M
dynamometer emissions testing.
Manufacturer of high - performance engine
dynamometers, chassis
dynamometers and flowbenches
used in all levels of engine and vehicle development.
In depth knowledge about engine
dynamometer test cell setup and instrumentation
used in test beds
Used small scale wind tunnel and
dynamometer for drag analysis of proposed tubular airfoil cross-section for
use as a bicycle frame, and gained working knowledge of oscilloscopes, multi-meters, thermocouples, flow meters, and data acquisition systems.
Aerobic fitness will be estimated
using the Chester step test (see below) and muscular fitness will be assessed with the hand grip strength
using a Jamar
dynamometer (see below).