Sentences with phrase «uses hydraulic brakes»

The GS 450h uses hydraulic brakes in the front and rear, and regenerative braking on the rear axle only.

Both brake types use a hydraulic braking system as well as a brake pad or brake shoe to create friction and cause a vehicle to stop when the driver applies pressure to the brake pedal.

Not exact matches

There are a few quirks to get used to — the brake pedal isn't a pedal, it's a touch - sensitive, pyramid - shaped rubber button where pressure, not pedal travel, equals stopping power; the feedback - free, hydraulic rack - and - pinion steering is as disconnected and consistent as a rheostat, and it feels like that of no other car on the planet — but the sharp - yet - pillowy ride and handling combination is almost supernatural.

It took a minute for Pilgrim to get used to the grabby, non-ABS brakes (being far less experienced with such brakes, I would later lock them up coming into Turn 2), and he would have liked a little less power in the hydraulic steering (Revology says that's doable), but he found the car pulls surprisingly hard to more than 7,000 rpm and sounds great with its Borla track exhaust, the Coyote making mighty thawwwwwacck racket at full chat.

A new adaptive suspension system uses electronically valved Sachs dampers to adjust stiffness and ride height, while hydraulic flaps actively divert air across the flat underbody to aid with brake cooling and downforce.

Electronic or electro hydraulic device installed in a tow vehicle used to activate the braking system of the trailer being towed.

Pressed rotors means that a hydraulic press must be used to separate the brake rotors from the wheel hubs.

The Leaf uses electronically controlled hydraulic brakes.

It then uses that information to control hydraulic pressure to the brakes and control wheel slip.

Loss of Hydraulic Pressure: The brake system uses hydraulic pressure to push the brake pads against thHydraulic Pressure: The brake system uses hydraulic pressure to push the brake pads against thhydraulic pressure to push the brake pads against the rotors.

The brake system uses pressure from hydraulic fluid to operate these components, applied to the piston in the Ford brake caliper.

The Cadillac brake caliper uses its piston, operated with pressure provided by a hydraulic fluid system, to move the brake pads inwards to make contact with the brake disc.

This system results in an improvement in regenerative braking efficiency compared to a hydraulic booster system used in other hybrids.

Cars use hydraulics to help the driver apply pressure to the brakes.

All brakes use a hydraulic system, wherein fluid moves through brake lines to create pressure which presses the brakes pads against the rotors and stops the car.

This system uses a belt or camshaft driven pump from the engine to pressurise a special hydraulic fluid, which then powers the brakes, suspension and power steering.

Examples of Vs are V - twin, V4, V6, V8, V10, V12 and V16 Vacuum Servo: The clever use of the engine partial vacuum to assist in pressurising the braking hydraulic system Valve: In engine parlance Valve is a device that opens and closes an air passage to let in or let out gasses Valve Bounce: A condition where the fast moving valve has exceeded its springs ability to keep from bouncing up off its valve seat at high rpm.

The company explained the iBooster and ESP - hev technology balance the use of the CT6 electric motors to act as generators to slow the vehicle and capture as much kinetic energy as possible during low - demand scenarios, while blending the traditional hydraulic brakes with the motors in high - demand scenarios.

The braking system in your vehicle uses a pressurized flow of hydraulic fluid to apply pressure to a piston in the Chrysler brake caliper, causing it to squeeze the brake pads into contact with the brake disc.

Although throttle, steering, and braking are all in someway or another computer controlled, the CR - V's all - wheel - drive system is controlled by simple hydraulics that use pressure supplied by pumps on the front and rear axles to determine torque split.

[48] Regenerative braking is used in conjunction with the standard hydraulic brake system which utilizes front - wheel discs and rear drums.

Hudson automobiles used an unusual hybrid hydraulic - mechanical dual - brake system which operated the rear brakes through the otherwise conventional mechanical parking brake system when a failure of the hydraulic system allowed the pedal to travel beyond its normal limit.

This uses sensors, software and electro - hydraulic actuators working through a multi-clutch plate to adjust the power and braking applied to each wheel all by itself.

Superior Stopping Power The front and rear setup use large 214 - mm disc brakes with hydraulic twin - piston calipers for superior stopping power.

A line lock is a temporary parking brake that makes use of the vehicles standard hydraulic brakes.

This is the hydraulic fluid used to transmit pressure through the brake lines in a brake system providing stopping power and protecting hydraulic brake components from internal corrosion.

Hydraulic pumps and a lightweight accumulator brake the vehicle, store the braking energy, and then use that stored energy to provide power to the wheels.

Brake fluid This is the hydraulic fluid used to transmit pressure through the brake lines in a brake system providing stopping power and protecting hydraulic brake components from internal corrosion.

DUTIES AND RESPONSIBILITIES MAY INCLUDE: - Examine damage vehicles, read and understand body repair estimates - Remove upholstery, accessories, electrical and hydraulic window - and - seat - operating equipment, and trim to gain access to vehicle body and fenders - Fill depressions with body filler - Remove damaged panels - Bolt or weld replacement parts in position, using wrenches or welding equipment - Straighten bent automobile frames - File, grind and sand repaired surfaces - Refinish repaired surface - Aim headlights, align wheels, and bleed hydraulic brake system - Repair or replace defective mechanical parts Job Requirements QUALIFICATIONS: - Two (2) years of experience as a vehicle body repairer or apprentice - Working knowledge of all aspects of repairs for damaged body parts and bodies of vehicles - Valid driver's license - State of Michigan mechanic certificate in body repair required WORKING CONDITIONS: This is a physically demanding position.

In addition to being used in antifreeze, it can also be found in hydraulic brake fluid, snow globes, and industrial solvents.

Ethylene glycol is also found in windshield washer fluid, brake fluid, hydraulic fluids, film processing solutions, paint solvents, and is used to de-ice airplanes and runways.

The season 5 car uses a «brake - by - wire» system, which means the brakes are electronically controlled, rather than through hydraulics and hoses.